Philips GC6830 - Инструкция по эксплуатации - Страница 9

11

Problem

Possible cause

Solution

The Calc-Clean process has 
not been completed.

You have to perform the Calc-Clean 
process again (see chapter ‘Cleaning and 
maintenance’).

Steam condenses into water 
in the hose when you use 
steam for the first time or 
have not used it for a long 
time.

This is normal. Hold the iron away from 
the garment and press the steam trigger.
Wait until steam instead of water comes 
out of the soleplate.

Dirty water and 
impurities come out of 
the soleplate.

Impurities or chemicals 
present in the water have 
deposited in the steam vents 
and/or soleplate.

Perform the Calc-Clean process 
regularly (see chapter ‘Cleaning and 
maintenance’).

Steam condenses into water 
in the hose when you use 
steam for the first time or have 
not used it for a long time.

This is normal. Hold the iron away from 
the garment and press the steam trigger.
Wait until steam instead of water comes 
out of the soleplate.

Water flushes out of the 
soleplate.

You have accidentally started 
the Calc-Clean process 
(see chapter 'Cleaning and 
maintenance').

Switch off the appliance. Then switch it 
back on again. Let the iron heat up until 
the ‘iron ready’ light lights up steadily.

The Calc-Clean process 
does not start.

You have not pressed the 
CALC-CLEAN button for 2 
seconds until the appliance 
started beeping.

See chapter ‘Cleaning and maintenance’.

The iron leaves a shine 
or an imprint on the 
garment.

The surface to be ironed was 
uneven, for instance because 
you were ironing over a seam 
or a fold in the garment.

PerfectCare is safe on all garments. The 
shine or imprint is not permanent and 
will come off if you wash the garment.
Avoid ironing over seams or folds or you 
can place a cotton cloth over the area to 
be ironed to avoid imprints.

There was not enough felt in 
the ironing board cover.

Put an extra layer of felt material under 
the ironing board cover.

The ironing board cover 
becomes wet, or there 
are water droplets on 
the floor/garment.

Steam has condensed on the 
ironing board cover after a 
long ironing session.

Replace the ironing board cover if the 
foam or felt material has worn out. 
You can also add an extra layer of felt 
material under the ironing board cover 
to prevent condensation on the ironing 
board.

You have an ironing board 
that is not designed to cope 
with the high steam rate of 
the appliance.

Put an extra layer of felt material under 
the ironing board cover to prevent 
condensation on the ironing board.

English