Philips GC6820 - Инструкция по эксплуатации - Страница 8

10

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you 
are unable to solve the problem with the information below, visit

 www.philips.com/support 

for a list 

of frequently asked questions or contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not 
produce any steam.

There is not enough water in 
the water tank.

Fill the water tank beyond the MIN 
indication. Press and hold the steam 
trigger until steam comes out. It may 
take up to 30 seconds until steam 
comes out.

You did not press the steam 
trigger.

Press and hold the steam trigger until 
steam comes out.

The steam function has 
been disabled until you have 
performed the Calc-Clean 
process.

Perform the Calc-Clean process to 
restore the steam function. (see chapter ' 
Cleaning and maintenance')

At the start of your ironing 
session, the steam trigger 
has not been pressed long 
enough.

Press and hold the steam trigger until 
steam comes out. It may take up to 30 
seconds until steam comes out.

The light of the CALC 
CLEAN button flashes 
and the appliance 
beeps.

This is the Calc-Clean 
reminder.

Perform the Calc-Clean after the Calc-
Clean reminder is given (see chapter 
‘Cleaning and maintenance’).

No steam comes out of 
the soleplate, the light 
of the CALC CLEAN 
button flashes and the 
appliance beeps.

You have not done or have 
not completed the Calc-Clean 
process.

Perform the Calc-Clean process to 
enable the steam function again (see 
chapter ‘Cleaning and maintenance’).

The appliance has 
switched off.

The auto shut-off function is 
activated automatically. The 
appliance enters the standby 
mode if has not been used for 
5 minutes and swiches off if it 
has not been used for another 
10 minutes.

To activate the appliance again, press 
the on/off button. The appliance starts 
to heat up again.

The appliance produces 
a loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press 
the steam trigger until the pumping 
sound becomes softer and steam comes 
out of the soleplate.

Water droplets come out 
of the soleplate.

After the Calc-Clean process 
remaining water may drip out 
of the soleplate.

Wipe the soleplate dry with a piece of 
cloth. If the Calc-Clean light still flashes 
and the appliance still beeps, perform 
the Calc-Clean process (see chapter 
‘Cleaning and maintenance’).

You have used the steam 
boost function too frequently.

Use the steam boost function only for 
stubborn creases. It is recommended 
not to use it for more than 5 times within 
3 minutes.

English