Philips Azur Pro GC4881/20 - Инструкция по эксплуатации - Страница 6

ENGLISH

8

 2 

 Fill the water tank to the MAX indication (Fig. 12). 

Do not pour vinegar or other descaling agents into the water tank. 

 3 

 Plug in the iron and set the temperature dial to MAX (Fig. 13-14).

 4 

 Unplug the iron when the temperature light goes out (Fig. 15-17).

 5 

  Hold the iron over the sink. Keep pushing the calc clean button and gently shake the 

iron forth and back until all water in the water tank has been used up (Fig. 18). 

Scales is flushed out, steam and boiling water also come out of the soleplate.

Note: Repeat steps 2 to 5 if the water that comes out of the iron still contains scale 

particles. 

 6 

 Plug in the iron and let the iron heat up to dry the soleplate (Fig. 19). 

 7 

 Unplug the iron when the temperature indicator light goes out. 

 8 

 Move the iron gently over a piece of cloth to remove any water stains on the 

soleplate. 

Troubleshooting

This chapter summarises the most common problems you could encounter with the 

appliance. If you are unable to solve the problem with the information below, visit  

www.philips.com/support

 for a list of frequently asked questions or contact the 

Consumer Care Centre in your country (see the worldwide guarantee leaflet for contact details).

Problem

Possible cause

Solution

Water leaks from the 
water filling door.

You have overfilled the 
water tank.

Do not fill the water tank 
beyond the 

MAX

 indication. 

Pour excess water out of the 
water tank.

Water drips from the 
soleplate after the iron 
has been unplugged 
or has been stored.

The steam slider is set to 

MAX

 or 

ECO

.

Set the steam slider to dry 
setting.

You have put the iron in 
horizontal position with water 
still left in the water tank.

Empty the water tank.

The steam boost 
function does not work 
properly (water leaks 
out of the soleplate).

You have used the steam 
boost function too often 
within a very short period.

Wait for a few seconds before 
you use the steam boost 
function again.

You have used the steam 
boost function at too low a 
temperature.

Set an ironing temperature at 
which the steam boost function 
can be used (

●●●

to 

MAX

).

Flakes and impurities 
come out of the 
soleplate during 
ironing.

Calc are formed inside the 
soleplate.

Use the calc clean function 
(see chapter ‘Cleaning and 
maintenance’, section  
‘Calc clean function’).