Утюги Bosch TDI 902431E - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
24
B O S C H
EN
G
lI
SH
You can download this manual from the local homepages of Bosch.
problem
probable cause
Solution
Water drips out
of the soleplate
together with
steam.
1. Temperature control (15) setting is too
low.
2. You have pressed the shot of steam
button (6) repeatedly without waiting
for 5 seconds between each press.
3. Pure distilled water has been used
(see “Filling the water tank” section)
or other products such as fragrant
water have been added to the tank.
1. Turn the temperature control (15)
to a higher setting (between “●●”
and “max”) and wait until the
“TempOK” lights inside the
temperature control stop lashing
and remain lit continuously.
2. Wait 5 seconds between each
press of the shot of steam button.
3. Mix distilled water with tap water
as directed in the “Filling the water
tank” section and never add any
other products to the water tank
(unless recommended by Bosch).
Steam does
not come out in
horizontal position.
1. Steam control is set to “ ” position.
2. No water in the tank (11).
3. The temperature is too low. Anti-drip
system is activated.
1. Set the steam control to “eco” or
“max” position.
2. Fill the tank (11).
3. Set to a higher temperature if
compatible with the fabric.
Excessive dripping
or steaming.
• No proper closing of “Calc’nClean”
system.
• Actuate a few times the
“Calc'nClean” button (16).
The pump does
not work
• The iron is not in a horizontal position. • Use the iron in a horizontal
position.
Spray does not
work.
1. No water in the tank (11).
2. Obstructed mechanism.
1. Fill the water tank.
2. Contact the Technical Service.
Smoke comes out
when connecting
the iron for the irst
time.
• This may be caused by the lubrication
of some of the internal parts.
• This is normal and will stop after a
few minutes.
Deposits come out
through the holes
in the soleplate
• Traces of lime scale are coming out of
the steam chamber.
• Carry out a cleaning cycle (see
“Calc’nClean” section).
The appliance
makes a pumping
sound
• Water is being pumped into the
steam chamber
• This is normal.
If none of the above solves the problem, get in touch with an authorised technical service.
