Sony STR-DE545 - Инструкция по эксплуатации - Страница 11

11

GB

Hooking Up the Components

CONTROL A1   hookup (STR-DE545 and
STR-SE501 only)

• If you have a CONTROL A1   compatible Sony

CD player, tape deck, or MD deck

Use a CONTROL A1 cord (not supplied) to connect the
CONTROL A1   jack on the CD player, tape deck, or
MD deck to the CONTROL A1   jack on the receiver.
Refer to the separate manual “CONTROL-A1   Control
System” and the operating instructions supplied with
your CD player, tape deck, or MD deck for details.

Note

If you make CONTROL A1   connections from the receiver to
an MD deck that is also connected to a computer, do not
operate the receiver while using the “Sony MD Editor”
software. This may cause a malfunction.

• If you have a Sony CD changer with a

COMMAND MODE selector

If your CD changer ’s COMMAND MODE selector can
be set to CD 1, CD 2, or CD 3, be sure to set the
command mode to “CD 1” and connect the changer to
the CD jacks on the receiver.
If, however, you have a Sony CD changer with VIDEO
OUT jacks, set the command mode to “CD 2” and
connect the changer to the VIDEO IN jacks on the
receiver.

AUX AUDIO IN hookup

• If you have an individual audio component

(except PHONO)

Use the audio cords to connect the LINE OUT jacks on
the CD player, tape deck, or MD deck to the AUX
AUDIO IN jack on the receiver so that you can listen to
stereo sources in surround sound.

Connecting the AC power cord

Before connecting the AC power cord of this receiver to a
wall outlet:
• Connect the speaker system to the receiver (see page

13).

Connect the AC power cord(s) of your audio/video
components to a wall outlet.

STR-DE545 and STR-SE501 only

If you connect other audio/video components to the AC
OUTLET(s) on the receiver, the receiver will supply power
to the connected component(s), allowing you to turn the
whole system on or off when you turn the receiver on or
off.

Caution

Make sure that the total power consumption of the component(s)
connected to the receiver ’s AC OUTLET(s) does not exceed the
wattage stated on the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons, fans, or TVs to
this outlet. (STR-DE545 and STR-SE501 only)

Note

If the AC power cord is disconnected for about two weeks, the
receiver ’s entire memory will be cleared and the demonstration
will start.