Усилители Pioneer VSX-420 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Controls and displays
02
12
En
Press
first to access:
BASS –/+
Use to adjust Bass
1
TRE –/+
Use to adjust Treble
1
11 Number buttons and other component
controls
2
Use the number buttons to directly select the
tracks on a CD, DVD, etc. There are other
buttons that can be accessed after the
button is pressed. (For example
TEST TONE
, etc.)
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.
TEST TONE
Outputs the test tones on each channel.
Use the
/
buttons to select the channel
and use the
/
buttons to adjust the
level on each channel. Pressing
TEST
TONE
again exits the test tone mode.
CH SELECT
Press repeatedly to select a channel, then
use
LEV +/–
to adjust the level
(page 34).
LEV +/–
Use to adjust the channel levels.
SPEAKERS
Use to change the speaker system on or
off. When the
SP OFF
is selected, no sound
is output from the speakers connected to
this receiver.
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
12
SOURCE
Turns on or off the power of the Pioneer DVD/
DVR units when
BD
,
DVD
or
DVR
is selected
using the
MULTI CONTROL
buttons.
13 TV CONTROL buttons
These buttons can control only be used with
Pioneer TVs.
Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
DTV/TV*
Switches between the DTV and analog TV
input modes for Pioneer TVs.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISP
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
17 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (
*
) in this section. This
button is also used for operating ZONE 2
(page 37).
Note
1 The tone controls are disabled when the listening mode is set to
DIRECT
or
PURE DIRECT
.
2
SB CH
button is not used with this receiver.
RECEIVER
RECEIVER
VSX-420_SY_En.book 12 ページ
年
月
９日 金曜日 午前９時
７分
