Триммеры STIGA GT 110c A 291850102/ST1 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
– Fix the line cutting knife in a vice and sharpen it
using a flat file, being careful to retain the origi
-
nal cutting angle.
– Refit the knife on the guard.
4. ELECTRIC CABLES
WARNING!
C
heck the condition of the
electric cables regularly and replace them if
they are worn or their insulation looks dam
-
aged.
If the appliance’s power supply wire is damaged,
it must be replaced by the manufacturer, service
agent or a similar qualified person.
5. EXTRAORDINARY MAINTENANCE
All maintenance operations not foreseen in this
manual must be performed exclusively by your
dealer.
All and any operations performed in unauthorised
centres or by unqualified persons will totally invali
-
date the warranty.
6. STORAGE
After every work stint, clean the machine thor
-
oughly to remove all dust and debris, and repair
or replace any faulty parts.
The machine must be stored in a dry place away
from the elements and out of the reach of children.
WARNING!
For your safety and that of
others:
– After each use, disconnect the machine
from the mains and check for damage.
– Correct maintenance is essential to main-
tain the original efficiency and safety of the
machine over time.
– Keep all nuts, bolts and screws tight to be
sure the equipment is in safe working con
-
dition.
– Never use the machine with worn or dam-
aged parts. Damaged parts are to be re-
placed and never repaired.
– Only use original spare parts. Parts that are
not of the same quality can seriously dam
-
age the equipment and compromise safety.
WARNING!
During maintenance op-
erations unplug the machine from the mains.
1. MOTOR COOLING
To avoid overheating and damage to the motor,
always keep the cooling air vents clean and free
of sawdust and debris.
2. HEAD COIL REPLACEMENT (Fig. 10)
– Follow the sequence indicated in the figure.
3. SHARPENING THE LINE CUTTING KNIFE
(Fig. 11)
– Unscrew the two screws (1) and remove the line
cutting knife (2) from the guard (3).
EN
10
MAINTENANCE AND STORAGE / ACCESSORIES
8. MAINTENANCE AND STORAGE
The table contains a list of all available accesso
-
ries, indicating those which may be used on each
machine, marked with the symbol “ ”.
WARNING!
In consideration that the
selection, application and usage of the ac ces-
sory to be fitted in the variety of possible us
-
age are actions made solely by the user, the
latter assumes responsibility for damages of
any kind due to such actions. When in doubt
or if lacking knowledge of the specificity of
each accessory, contact your retailer or spe
-
cialised gardening centre.
9. ACCESSORIES
Code
Model T 1.0 EJ
118801750/0 (M8 x 1,25 dx M)
