Bosch ART 35 0.600.878.M21 - Инструкция по эксплуатации - Страница 11

 English | 

11

Bosch Power Tools

F 016 L81 763 | (29.8.17)

Keep the supply cables away from mov-
ing hazardous parts and avoid damage 
to the cables; this can lead to contact 
with live parts.
The connections (plugs and sockets) 
should be kept dry and off the ground.
The supply cables must be inspected 
for signs of damage at regular intervals 
and may only be used if in perfect con-
dition.
If the supply cable on the product is 
damaged, it must only be replaced by a 
Bosch Service Centre.
Only use approved extension cables.
Extension cords, cables, leads, reels 
should only be used if they comply with  
EN 61242/IEC 61242 or 
IEC 60884-2-7.
If you want to use an extension cable 
when operating your product, only the 
following cable dimensions should be 
used:
– Nominal Conductor Area of 

1.25 mm

2

 or 1.5 mm

2

– Maximum length of 30 m for a Cord 

Extension Set or maximum length of 
60 m for a Cable Reel with Residual 
Current Device (RCD

Note: If an extension cable is used it 
must be earthed and connected 
through the plug to the earth cable of 
your supply network in accordance 
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.

WARNING! Inadequate exten-
sion cables can be dangerous. 
Extension cable, plug and 

socket must be of watertight con-
struction and intended for outdoor 
use.

For products 

not sold in GB

:

WARNING:

 For your safety, it is re-

quired that the plug attached to the 
product is connected with the exten-
sion cord. The coupling of the exten-
sion cord must be protected against 
splash water, be made of rubber or 
coated with rubber. The extension cord 
must be used with a cable strain relief.



Products sold in GB only:

 Your prod-

uct is fitted with a BS 1363/A ap-
proved electric plug with internal fuse 
(ASTA approved to BS 1362).
If the plug is not suitable for your 
socket outlets, it should be cut off 
and an appropriate plug fitted in its 
place by an authorised customer ser-
vice agent. The replacement plug 
should have the same fuse rating as 
the original plug.
The severed plug must be disposed of 
to avoid a possible shock hazard and 
should never be inserted into a mains 
socket elsewhere.

Products sold in AUS and NZ only:

Use a residual current device (RCD) 
with a rated residual current of 30 mA 
or less.

Symbols

The following symbols are important for reading and under-
standing the operating instructions. Please take note of the 
symbols and their meaning. The correct interpretation of the 
symbols will help you to use the garden product in a better 
and safer manner.

OBJ_BUCH-1800-004.book  Page 11  Tuesday, August 29, 2017  8:22 AM