Microlife BP A110 - Инструкция по эксплуатации - Страница 8

6

Memory full

Clearing all values

If you are sure that you want to permanently remove all stored 
values, hold down the M-button (the instrument must have been 
switched off beforehand) until «

CL

» appears and then release the 

button. To permanently clear the memory, press the M-button 
while «

CL

» is flashing. Individual values cannot be cleared.

8. Battery Indicator and Battery change

Low battery

When the batteries are approximately ¾ empty the battery symbol 

AR

 will flash as soon as the instrument is switched on (partly filled 

battery displayed). Although the instrument will continue to 
measure reliably, you should obtain replacement batteries. 

Flat battery – replacement

When the batteries are flat, the battery symbol 

AR

 will flash as soon 

as the instrument is switched on (flat battery displayed). You cannot 
take any further measurements and must replace the batteries.

Which batteries and which procedure?

Using rechargeable batteries

You can also operate this instrument using rechargeable batteries.

9. Using a Mains Adapter

You can operate this instrument using the Microlife mains adapter 
(DC 6V, 600mA). 

When the mains adapter is connected, no battery current is consumed.

10. Error Messages

If an error occurs during the measurement, the measurement is 
interrupted and an error message, e.g. «

ERR 3

», is displayed.



Pay attention that the maximum memory capacity of 200 is 
not exceeded. 

When the memory is full, the old values 

are automatically overwritten with new ones.

 Values 

should be evaluated by a doctor before the memory capacity 
is reached – otherwise data will be lost.

1. Open the battery compartment 

AT

 at the back of the instrument.

2. Replace the batteries – ensure correct polarity as shown by the 

symbols in the compartment.

3. To set date and time, follow the procedure described in 

«Section 3.».

H

The memory retains all values although date and time (and 
possibly also set alarm times) must be reset – the year 
number therefore flashes automatically after the batteries 
are replaced.

H

Use 4 new, long-life 1.5V, size AA batteries.

H

Do not use batteries beyond their date of expiry.

H

Remove batteries if the instrument is not going to be used 
for a prolonged period.

H

Only use «NiMH» type reusable batteries.

H

Batteries must be removed and recharged when the flat 
battery symbol appears. They should not remain inside the 
instrument as they may become damaged (total discharge as 
a result of low use of the instrument, even when switched off).

H

Always remove the rechargeable batteries if you do not 
intend to use the instrument for a week or more.

H

Batteries cannot be charged in the blood pressure monitor. 
Recharge batteries in an external charger and observe the 
information regarding charging, care and durability.

H

Only use the Microlife mains adapter available as an orig-
inal accessory appropriate for your supply voltage, e.g. the 
«Microlife 230V adapter».

H

Ensure that neither the mains adapter nor the cable are 
damaged.

1. Plug the adapter cable into the mains adapter socket 

8

 in the 

blood pressure monitor.

2. Plug the adapter plug into the wall socket.

Error

Description Potential cause and remedy

«

ERR 1

» Signal too 

weak

The pulse signals on the cuff are too weak. 
Re-position the cuff and repeat the 
measurement.*

«

ERR 2

» Error signal

During the measurement, error signals were 
detected by the cuff, caused for instance by 
movement or muscle tension. Repeat the 
measurement, keeping your arm still.