BRAYER BR1091 - Инструкция по эксплуатации - Страница 8

8

EN

and the thermopot will be switched to the keep warm 

mode, the keep warm indicator (19) «85» will light up. 

The water temperature 85°С is set by default.

Notes:

 the thermopot uses a long boiling technology 

which significantly reduces the chlorine level in water.

•  To avoid burns by hot steam, do not bend over the 

steam release openings (7) in the thermopot lid (5). 

Do not block the steam release openings (7) with any 

objects.

• 

Drain the water after the first boiling. Hot water 

resulting from the first boiling is not recommended to 

consume, you may use it for domestic needs.

ATTENTION! 
Be careful when pouring out water to avoid burns 

by hot water.

•  Unlock the activation of the water pump by pressing 

and holding the «Lock» button (18) within 5 seconds, 

the indicator (17) will light up.

•  To drain the water you can do the following:

First option:

 place a suitable bowl, for instance, a cup 

under the spout for pouring water (3) and press the 

water (2) dispense button with a rim of the cup (pic. 3).

Second option: 

place a suitable bowl under the spout 

for pouring water (3) and press and hold the water 

dispense button (16) «Water dispense», after the cup is 

filled release the button (16).

Notes: 

- the water is dispensed only when the indicator (17) is 

switched on; if you pressed the button (18) «Lock» and 

didn’t do anything, in this case the indicator (17) will go 

out in 10 seconds;
- if you haven’t used the thermopot for a long time, 

the water dispense may malfunction. In this case it 

is recommended to open and close the lid (5) and to 

switch the water dispense on again.
• 

To switch the thermopot off disconnect the power 

cord (22) plug from the mains socket.

•  Open the thermopot lid (5) and wait until it cools 

down completely.

•  Always drain the remaining water from the thermopot 

flask, to do this remove the lid (5).

•  Before removing the lid (5) slightly open it at the 

angle of approximately 45°, and pull the lid (5) 

towards the control panel (4) (pic. 2).

•  Carefully tilt the thermopot to drain the remaining 

water (pic. 3).

•  Install the lid (5) to its place; to do this, set the lid 

(5) at the angle of approximately 45° and insert 

the lid (5) to its installation place; before using the 

thermopot make sure that the lid (5) is fixed properly.

Additional information

•  The thermopot is equipped with rotating base (12). 

You can turn the thermopot body (10) in the required 

direction.