Brayer BR1091 (MULTI) - Инструкция по эксплуатации - Страница 9

9

EN

•  Check the water level in the thermopot using the 

scale (1).

• 

Timely refill the thermopot.

HOT WATER MAINTENANCE TEMPERATURE 

SELECTION

• 

You can select one of five presets of hot water 

temperature maintenance. 

•  To select the hot water maintenance temperature 

press the button (21) «Selection of С°», you can 

select the hot water maintenance temperature of 

«95-85-65-55-45» degrees.

•  Recommended water temperature for brewing tea 

and making other beverages:

•  - «45» - water temperature for making powdered 

baby milk

•  - «55» - brewing white tea

•  - «65» - red or herbal tea

• 

- «85» - green or yellow tea, brewing coffee

•  - «95» - black tea

•  The preset keep warm temperature is shown by the 

corresponding indicators (19).

• 

If the water temperature goes significantly below 

the preset temperature (for example, if you added 

cold water), the boiling mode will switch on and the 

indicator (14) «Boiling» will light up.

•  You can switch the reboiling mode on by pressing the 

button (13) «Reboiling», the indicator (14) «Boiling» 

will light up. After water boiling you will hear a sound 

signal and the keep warm mode will switch on, the 

keep warm indicator (19) «85» will light up. The water 

temperature 85°С is set by default.

• 

To switch the thermopot off disconnect the power 

cord (22) plug from the mains socket.

CLEANING AND  MAINTENANCE

•  Before cleaning the thermopot unplug it (22), open 

the lid (5) and wait until the thermopot cools down 

completely.

•  Always drain the remaining water from the thermopot 

flask, to do this remove the lid (5).

•  Before removing the lid (5) slightly open it at the 

angle of approximately 45°, and pull the lid (5) 

towards the control panel (4) (pic. 2).

•  Carefully tilt the thermopot to drain the remaining 

water (pic. 7).

•  Install the lid (5) to its place; to do this, set the lid 

(5) at the angle of approximately 45° and insert 

the lid (5) to its installation place; before using the 

thermopot make sure that the lid (5) is fixed properly.

•  Clean the outer surface of the thermopot body (10) 

with a slightly damp cloth and then wipe it dry.

•  Use neutral detergents to remove dirt, do not use 

metal brushes, abrasives and solvents.

•  Do not immerse the thermopot and the power cord 

(22) into water or other liquids.

•  Do not put the thermopot in a dishwashing machine.