Cooper&Hunter CH-F1500 - Инструкция по эксплуатации - Страница 8

www.cooperandhunter.com

6

TIMER FUNCTION:

1. In working mode, press the button “       ” and “      ”  at the same time 

to set automatic off of the product. The LED display will switch to timer 
setting, the figures flash on screen, as below:

NOTE:

1. The temperature SET should be higher than 

the room temperature, otherwise, the appliance 

will not start heating.

2. Once the room temperature achieves the 

target temperature, the appliance will stop 

automatically, the fan inside will power off 30s 

later.

3. If the room temperature is 1°C less than

temperature SET, the appliance will restart.

2. To deactivate timer function press the button “     ” and “     ”  at the 
same time.
3. The appliance can be set between 1 to 8 hours, increased at 1 hour 
intervals.
4. To adjust the timer press “     ” or “     ” buttons then wait a few 
seconds for the setting to be memorized.

NOTE:

Figures will keep flashing on the screen until the

program setting is finished

5. After setting finished, screen will automatically show “Temperature” - 
“Timer” – “Temperature” in turns within 5 second each.

NOTE:

Timer on screen will decrease at 0.1 hour

intervals, eg: 2.8 hours.

6. When the programmed time is reached, the heater stop working, the 
fan inside will power off 30s later.

TI

P-OFF SAFETY DEVICE:

This appliance is provided with a safety device which will switch off the 

heater in case of accidental tipping off (90°forward). When the heater 
stop working, the fan inside will power off 30s later, the LED display and 
indicator light will flash to alert the user to correct the appliance, 
meanwhile, the buzzer will beep continuously. The heating is resumed 
after the appliance is right up, the LED display and indicator light stop 
flashing and the buzzer stops alarming.

NOTE:

The appliance works normally except that it is

tilted 90° forward.

MULTI-ANGLE USE:

This appliance can be use at multiple angles with flexible wind direction, 

but the angles shown as picture 5 and 6 are not allowed.

IMPORTANT!

The appliance works properly at the angle of 
picture 6, which is forbidden for safety 
concerns.