Bosch 0.601.944.302 - Инструкция по эксплуатации - Страница 18

18

 | English 

1 609 929 S53 | (26.11.08)

Bosch Power Tools

Programming Operation

In programming operation, it is possible to 
continuously store the air-flow and temperature 
adjustments in four programs. Each program 
allows for different air-flow and temperature 
combinations.
In progamming operation, it is also possible to 
change the air flow and temperature any time. 
When the changes are not saved, they are lost 
after switching off or changing to a different 
program.
To change to programming operation, press the 
program-selection button 

6

 until the number of 

the requested program is indicated in the dis-
play 

7

.

The following four programs are preset in the 
condition of delivery:

To change a set program, switch to this program 
by pressing the program-selection button 

6

. Set 

the requested air flow and temperature with the 
air-flow control button 

8

 and the temperature-

control button 

9

.

As soon as the settings of a program have been 
changed, the   symbol flashes in the left top of 
the display. Once the requested air flow and 
temperature are set, press the save button 

10

until the   symbol in the display goes out. The 
set values are now stored under the program 
number indicated in the display.

Normal Operation

To switch from programming operation to nor-
mal operation, press the program-selection but-
ton 

6

 as often as required until no program 

number is indicated above the temperature in 
the display. The air flow and temperature can be 
changed anytime with the air-flow control but-
ton 

8

 and the temperature-control button 

9

.

Under the following conditions, the values for 
air flow and temperature set in normal opera-
tion will remain stored:
– When changing to programming operation,
– When changing to the cool-air stage,
– When switching the power tool off.

Working Advice

Note: 

Do not apply the nozzle 

4

 too close to the 

workpiece being worked. The hot air build-up 
can lead to overheating of the power tool.

Removing the Heat Protection

The heat protection collar 

5

 can be removed 

when working at particularly hard-to-reach loca-
tions.

f

Be careful of the hot nozzle! 

Increased dan-

ger of burning exists when working without 
the heat protection collar.

To remove or mount the heat protection collar 

5

, 

switch the power tool off and allow it to cool 
down.
To cool down the power tool more quickly, you 
can operate it for a few moments in the cool-air 
stage.
Turn the heat protection collar 

5

 in anticlock-

wise direction to remove and in clockwise direc-
tion to mount again.

Placing Down the Power Tool (see figure C)

To cool down the power tool or have both hands 
free, place it down on the standing surface 

1

.

f

Be especially careful when working with the 
placed down power tool! 

There is danger of 

burning oneself on the hot nozzle or on the 
hot air jet.

Program

Application

Temperature 

in

 °

C

Air Flo

w

1

Deforming plastic tubing 
(e. g. LDPE) 

250

2

Welding plastic (e. g. PVC) 

350

3

Removing Varnish/
Softening Adhesives

450

4

Soldering

550

OBJ_BUCH-485-002.book  Page 18  Wednesday, November 26, 2008  11:54 AM