Сварочное оборудование FUBAG Plasma 20 AIR - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
www.fubag.ru
O
m
perator's
anual
- 6 -
8. Troubleshooting
9. Transport & torage
10. Warranty
s
When the
is in storage and transportation, please try to keep it from being exposed to the
rain. When loading, attach ATTENTION to the
packing. It is recommended to free it from
moisture, erodible gas and dust in storage where it must be kept dry and have good ventilation. The
tolerable temperature, and the relative humidity.
After the package has been opened, it is suggested to repack the product as per requirement for
future storage and transport.
Warranty refer to defects of materials and components and do not refer to components subject to
natural wear and maintenance work.
Only machines cleaned from dust and dirt in original factory packing fully completed, provided with
instruction manual, warranty card with fixed sales date with a shop stamp factory serial number and
originals of sales and ware receipt issued by salesman are subjects of warranty. Within the warranty
period the service center eliminate free of charge all detected production defects. The manufacturer
disclaims warranty and legal responsibilities if nonobservance of the instruction manual by user,
unqualified disassembling repair or maintenance of the machine as well does not bear responsibility
for caused injury to persons or damages.
plasma
plasma
ANOMALIES
CAUSES
REMEDIES
The machine delivers no power.
The green working indicator is
on. The thermal protection
indicator is continuously on.
The thermal protection
of the welding unit is on.
Wait until the end of the cooling phase.
The machine delivers no power.
The green working indicator is
on. The thermal protection
ondicator blinks 2 times then
lights off.
The input voltage is
outside the limits.
Check your electrical network or your
electric generator then switch off and
on your machine.
Torch defect.
Check your torch assembly.
The machine delivers no power.
The green working indicator is
on. The thermal protection
indicator blinks quickly.
Air supply too weak.
Increase the air pressure, then switch
off and on your machine.
By pressing the trigger, the air
flows but the pilot arc is not
working.
Consumables shabby.
Check and change the consumables,
then switch off and on your machine.
The electrical arc switches off
after about 3 seconds.
Earth problem.
Check the earth clamp is well
connected to a clean area (not painted
and not fat) of the part to cut.
After having switched off the
plasma (position «O»), the
ventilator and the compressed
air continues to run.
Torch Cooling phase
Normal behaviour of the machine, wait
for the end of the cooling phase (+/-15
sec).
