Ryobi R18PV-0 - Инструкция по эксплуатации - Страница 16

2

| English

SAFETY WARNINGS FOR BLOWER

■

Wear a face filter mask in dusty conditions to reduce 
the risk of injury associated with the inhalation of dust.

■

Do not point the blower nozzle in the direction of people 
or pets.

■

Never place objects inside the nozzle or hose.

■

Do not operate the product near open windows.

■

Slightly dampen surfaces in dusty conditions.

■

Do not place the product on top of or near loose debris. 
Debris may be sucked into intake vent resulting in 
possible damage to the product.

■

Do not operate the product with defective guard, 
enclosure or shields.

■

Always be sure of the footing on slopes and to walk, 
never run.

■

Do not touch moving hazardous parts before the 
product is disconnected from the power supply/battery 
pack and the moving hazardous parts have come to a 
complete stop.

■

Always wear substantial footwear and long trousers 
while operating the product.

■

If the product is dropped, suffers heavy impact or 
begins to vibrate abnormally, immediately stop the 
product and inspect for damage or identify the cause of 
the vibration. Any damage should be properly repaired 
or replaced by an authorised service centre.

BATTERY AND CHARGER SAFETY

■

Connect and disconnect the battery pack properly.

●

To install battery pack:

–

Place the battery pack on the product.

–

Make sure the latches on each side of the 
battery pack snap into place and the battery 
pack is secured on the product before beginning 
operation.

●

To remove battery pack:

–

Depress the latches on the side of the battery 
pack.

–

Remove the battery pack from the product.

■

A battery operated product with integral batteries or a 
separate battery pack must be recharged only with the 
specified charger for the battery. A charger that may be 
suitable for one type of battery may create a risk of fire 
when used with another battery.

■

Do not expose charger to wet or damp conditions.

■

Do not place batteries near fire or heat. They may 
explode.

■

Do not expose a battery pack or tool to fire or excessive 
temperature. Exposure to fire or temperature above 
130 °C may cause explosion.

■

Do not place product near any heat sources such as 
radiators, heat registers, stoves, or other products 
(including amplifiers) that produce heat.

■

Batteries can explode in the presence of a source 
of ignition, such as a pilot light. To reduce the risk of 
serious personal injury, never use any cordless product 
in the presence of open flame. An exploded battery 
can propel debris and chemicals. If exposed, flush with 

water immediately.

■

Battery products do not have to be plugged into an 
electrical outlet; therefore, they are always in operating 
condition. Be aware of possible hazards when not using 
your battery product or when changing accessories. 
Following the rule will reduce the risk of electric shock, 
fire, or serious personal injury.

■

Danger of explosion if battery is incorrectly replaced. 
Replace only with the same or equivalent type.

■

Use of an attachment not recommended or sold by the 
battery charger manufacturer may result in a risk of fire, 
electric shock, or injuries to person.

■

When battery pack is not in use, keep it away from 
other metal objects like paper clips, coins, keys, nails, 
screws, or other small metal objects that can make a 
connection from one terminal to another. Shorting the 
battery terminals together may cause sparks, burns, or 
a fire.

■

To reduce risk of damage to charger body and cord, pull 
by charger plug rather than cord when disconnecting 
charger.

■

For best results, your battery product should be 
charged in a location where the temperature is more 
than 10°C (50°F) but less than 38°C (100°F). To reduce 
the risk of serious personal injury, do not store outside 
or in vehicles.

■

Follow all charging instructions and do not charge the 
battery pack or tool outside the temperature range 
specified in the instructions. Charging improperly or at 
temperatures outside the specified range may damage 
the battery and increase the risk of fire.

■

Do not charge battery product in a damp or wet location. 
Following the rule will reduce the risk of electric shock.

■

Make sure cord is located so that it will not be stepped 
on, tripped over, or otherwise subjected to damage and 
stress.

■

Do not crush, drop or damage battery pack. Do not use 
a battery pack or charger that has been dropped or 
received a sharp blow. A damaged battery is subject to 
explosion. Properly dispose of a dropped or damaged 
battery immediately.

■

An extension cord should not be used unless absolutely 
necessary. Use of improper extension cord could result 
in a risk of fire and electric shock. If extension cord must 
be used, make sure:

a)  That pins on plug of extension cord are the same 

number, size and shape as those of plug on 
charger.

b)  That extension cord is properly wired and in good 

electrical condition.

■

Do not operate charger with a damaged cord or plug. If 
damaged, have it replaced immediately by a qualified 
serviceman.

■

Do not disassemble charger; take it to a qualified 
serviceman when service or repair is required. Incorrect 
reassembly may result in a risk of electric shock or fire.

■

Disconnect charger from power supply when not in use.

■

Risk of electric shock. Do not touch uninsulated portion 
of output connector or uninsulated battery terminal.

■

Do not use a battery pack or tool that is damaged or 
modified. Damaged or modified batteries may exhibit