Ariston ALD 140 - Инструкция по эксплуатации - Страница 26

M

ARGHERITA

Margherita - Instructions for installation and use

Model

ALD 140

Dimensions

width 59,5 cm
height 85 cm

depth 53,5 cm

Capacity

from 1 to 5 kg

Electrical

connections

voltage 220/230 Volt 50 Hz
maximum absorbed power 1850 W

Water

connections

maximum pressure 1 MPa (10 bar)
minimum pressure 0,05 MPa (0,5 bar)

drum capacity 46 litre

Spinning speed

up to 1400 rpm

Control programs

in compliance
with IEC
regulation 456

programme 3; temperature 60°C; rinse level                ; wash intensity                     ;

carried out with 5,0 kg load

This appliance conforms with the following E.E.C. directives:

- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications

The washing machine
does not drain or spin.

D o e s   t h e   s e l e c t e d
programme incorporates
w a t e r   d r a i n i n g ?

  S o m e

programmes stop at the end of
the wash cycles and draining
will have to be selected
manually.

Is the “Easy iron"  function
-where provided - enabled?

Complete the programme by
pressing the 

Select 

button.

Is the drain pump clogged?

To check it, turn off the water
supply, unplug the washing
m a c h i n e   a n d   f o l l o w   t h e
instructions on page 25, or call
for technical assistance.

Is the drain hose kinked?

The tract of the drain hose
must be as straight as possible.
Make sure the drain hose is not
squashed or kinked.

Is the washing machine’s
drain duct clogged? 

Is there

an extension of the drain
hose? If so, is it positioned
incorrectly, blocking the water
flow?

Excessive vibration
during the spin cycle.

Have all transit screws been
removed durind instal-
lation? 

See the following

p a g e   o n   i n s t a l l a t i o n
procedures.

Has the washing machine
been levelled correctly?

 The

levelling of the appliance
s h o u l d   b e   c h e c k e d
periodically. Adjust the feet
and check them with a level.

Is there space between the
machine and adjacent units?

If it is not a built-in model, the
washing machine will oscillate
a bit during the spin cycle. A
few cm of space should
therefore be left around it.

The washing machine
leaks.

Is the metal ring of the inlet
hose properly attached? 

Turn

off  the water supply, unplug
t h e   a p p l i a n c e   a n d   t r y
tightening its attachment
without forcing it.

Is the detergent dispenser
obstructed? 

Remove and

wash it under tap water.

I s   t h e   d r a i n   h o s e   w e l l
attached?

 Turn off the water

supply, unplug the appliance
a n d   t r y   t i g h t e n i n g   i t s
attachment.

Too much foam.

Is the detergent appropriate
for machine washing?

 Check

whether the definition on its
label reads “for machine wash”
or “hand and machine wash”,
or any other similar wording.

Is the correct amount being
used? 

An excessive amount of

detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.

If ,  d e s p i t e   a l l   c h e c k s , t h e
w a s h i n g   m a c h i n e   f a i l s   t o
f u n c t i o n   a n d   t h e   p r o b l e m
persists , call your nearest
authorised Customer Service
Centre, providing the following
information:
- the nature of malfunction
- the model type no. (Mod. ....)
-   the serial number (S/N ....)
This information can be found on
the data plate situated at the back
of the washing machine.

Technical characteristics

Always get

assistance from

authorised

technicians and

always insist on

original spare

p a r t s .

23