Zanussi FA 622 (Aquacycle 600) - Инструкция по эксплуатации - Страница 19

ENGLISH

19

4. The water inlet hose filter

If it takes longer to fill up the washing machine it is
time to check the water inlet hose filter it may be
clogged. 

Turn off the water tap. 

Unscrew the fixing nut of the inlet hose. 

Remove the filter from the electrovalve and clean it
with a hard bristle brush and replace it. 

Screw on the nut thoroughfully.

5. Emergency emptying out

If the water is not discharged (outlet pump is
blocked, filter or drain hose are clogged), proceed as
follows to empty out the machine:

• pull out the plug from the power socket; 

• close the water tap; 

• if necessary, wait until the water has cooled down;

• open the drainage area door;

• place a bowl to collect the water;

• release the emergency emptying hose, place it in

the bowl and remove its cap, when the bowl is full
put the cap back on the emergency emptying hose;

• empty the bowl, repeat the procedure until you

have completely emptied the washing machine;

• replace the emergency emptying hose in its initial

position and close the drainage area door.

P0090

P0021

6. Frost precautions

If the machine is installed in a place where the
temperature could drop below 0°C, proceed as
follows:

• disconnect the appliance;

• close the water tap;

• if necessary, wait until the water has cooled down;

• open the drainage area door;

• place a bowl to collect the water that will flow out;

• release the emergency emptying hose, place it in

the bowl and remove its cap;

• when the water stops flowing out, put the cap back

on the emergency emptying hose, replace the
emergency emptying hose in its initial position and
close the drainage area door.

By doing this, any water remaining in the machine is
removed, avoiding the formation of ice and,
consequently, breakage of the affected parts.

When you use the machine again, make sure that
the ambient temperature is above 0°C.