Indesit WD 84 T - Инструкция по эксплуатации - Страница 13

Too much foam.

Is the detergent appropriate
for machine washing?

 Check

whether the definition on its
label reads “for machine wash”
or “hand and machine wash”,
or any other similar wording.

Is the correct amount being
used? 

An excessive amount of

detergent, besides producing
too much foam, does not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.

The washer-dryer does
not dry.

Check whether:

the plug has been correctly
inserted into the socket; there
is electricity in your home; the
appliance door has been shut
properly; a delayed star t (if
a v a i l a b l e )   h a s   n o t   b e e n
selected; programme knob 

A

has been set to position 
(Stop/Reset); the drying cycle
k n o b  

C

  h a s   b e e n   s e t   t o

position 

0

.

The washer-dryer doesn't
dry properly.

Check whether:

the end of the drain hose is
underwater; the drain pump is
obstructed; the advice given
on the maximum loads has
been taken; the water tap has
been turned on.

If, despite all checks, the washer-
dryer  fails to function and the
p r o b l e m   p e r s i s t s ,   c a l l   y o u r
nearest authorised Customer
Service Centre, providing the
following information:
- the nature of malfunction
- the model type no. (Mod. ....)
-   the serial number (S/N ....)
This information can be found on
the data plate situated at the back
of the washer-dryer.

Is there space between the
m a c h i n e   a n d   a d j a c e n t
units?

 If it is not a built-in

model, the washer-dryer will
oscillate a bit during the spin
cycle. A few cm of space
s h o u l d   t h e r e f o r e   b e   l e f t
around it.

The washer-dryer leaks.

Is the metal ring of the inlet
hose properly attached?

Tur n off  the water supply,
unplug the appliance and try
t i g h t e n i n g   i t s   a t t a c h m e n t
without forcing it.

Is the detergent dispenser
obstructed? 

Remove and

wash it under tap water.

I s   t h e   d r a i n   h o s e   w e l l
attached?

 Turn off the water

supply, unplug the appliance
a n d   t r y   t i g h t e n i n g   i t s
attachment.

Is the drain hose kinked?

The tract of the drain hose
m u s t   b e   a s   s t r a i g h t   a s
possible. Make sure the drain
h o s e   i s   n o t   s q u a s h e d   o r
kinked.

Is the washer-dryer’s drain
duct clogged? 

Is there an

extension of the drain hose?
I f   s o,   i s   i t   p o s i t i o n e d
i n c o r r e c t l y,   b l o c k i n g   t h e
water flow?

Excessive vibration
during the spin cycle.

Have all transit screws been
r e m o v e d   d u r i n d   i n s t a l -
lation? 

See the following

p a g e   o n   i n s t a l l a t i o n
procedures.

Has the washer-dryer been
l e v e l l e d   c o r r e c t l y ?

  T h e

l e v e l l i n g   o f   t h e   a p p l i a n c e
s h o u l d   b e   c h e c k e d
periodically. Adjust the feet
and check them with a level.

The washer-dryer does
not drain or spin.

D o e s   t h e   s e l e c t e d
programme incorporates
w a t e r   d r a i n i n g ?

  S o m e

programmes stop at the end
o f   t h e   w a s h   c y c l e s   a n d
d r a i n i n g   w i l l   h a v e   t o   b e
selected manually.

I s   t h e  “ A n t i - c r e a s e "
function -where provided -
e n a b l e d ?

  T h i s   f u n c t i o n

requires manual selection for
draining.

Is the drain pump clogged?

To check it, turn off the water
supply, unplug the washer-
d r y e r   a n d   f o l l o w   t h e
instructions on page 12, or
call for technical assistance.

Technical characteristics

Always get

assistance from

authorised

technicians and

always insist on

original spare parts.

Instructions for installation and use 

10

Model

WD 84 T

Dimensions

width 59,5 cm

height 85 cm
depth 53,5 cm

Capacity

from 1 to 5 kg for the wash programme; from 1 to 3,5 kg for the drying programme

Electrical
connections

voltage 220/230 Volt 50 Hz

maximum absorbed power 1850 W

Water connections

maximum pressure 1 MPa (10 bar)
minimum pressure 0,05 MPa (0,5 bar)
drum capacity 46 litre

Spinning speed

up to 800 rpm

Control programs
in compliance with
IEC regulation 456

wash: programme 3; temperature 60°C; carried out with 5 kg load.

drying: run with a load of 2.5 kg and knob C et to position      .

This appliance conforms with the following E.E.C. directives:
- 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent

modifications