Indesit W 125 TX - Инструкция по эксплуатации - Страница 17

What goes in your washer?

Before  washing, you can do a great deal to ensure better results. Divide your garments
according to fabric and colour. Read the labels, follow their guidelines.

Before washing.

Divide your washing according
to the type of fabric and colour
fastness.
Empty all pockets (coins, paper,
money and small obejects) and
ensure all loose buttons are
repaired or removed prior to
loading.

How to eliminate the most common stains

Ink and biro

 Dab with a wad of cotton soaked in methyl alcohol or alcohol at 90°.

Tar

 Dab with fresh butter, rub in turpentine then wash immediately.

Wax

 Scrape away, then run a hot iron between two sheets of absorbent paper. Then rub in cotton with turpentine or

methyl alcohol.

Chewing gum

 Rub in nail polish remover and wipe with a clean rag.

Mold

 Cotton and white linen should be placed in a solution of 5 parts water, one bleach and a spoon of vinegar, then

washed immediately. For other white fabrics, use hydrogen peroxide at 10 volumes and wash immediately.

Lipstick

 Dab with ether on wool or cotton. Use tricloroetilene for silk.

Nail polish

 Place a sheet of absorbent paper on the side of the stain, wet it with nail polish remover, shifting the

garment as the sheet gradually changes colour.

Grass

 Dab with a wad of cotton soaked in methyl alcohol.

Starting the washer

Starting your washing machine
in the right way is impor tant for
the quality of your wash, to help
prevent future problems and
enhance life expectancy of your
a p p l i a n c e .   O n c e   y o u   h a v e
loaded your washing machine
a n d   a d d e d   t h e   d e t e r g e n t
t o g e t h e r   w i t h   a n y   f a b r i c
conditioner, always check that:

1. The door is closed correctly.
2. The plug is secured in the
socket.
3. The water supply is turned
on.
4. Selector knob 

A

 is positioned

on one of the symbols   (Stop/
Reset).

Choose the desired programme

The programme is selected
according to the type of garments
that need to be washed. To choose
a programme, refer to the table on
page 16. Turn knob 

A

 until the

selected programme is aligned
with the mark on the knob, turn
knob 

B 

to the desired temperatu-

re settings, check that knob 

C

 is

i n   t h e   d e s i r e d   p o s i t i o n ,   i f
necessary use buttons 

E, F, G

and 

H

, and lastly, press on/off

button 

I

 (

I

position).

After installing your new washing machine, start a wash
cycle by setting programme "1" at 90 degrees.

For more delicate

garments:

protect underwear, tights

and stockings and delicate
items by placing them in a

canvas pouch

Dividing your garments

according to fabric and

colour, is very important

for good results

Remember that, if you want to
use it, the "programmed star t"
should be set before the wash
cycle.

At the end of the wash cycle...

The 

M

 lamp to extinguish: it will

take about three minutes.
Then turn the washing machine
off by pressing on-off button 

I

 (

O

position). You can now open the
washing machine door safely.
A f t e r   h a v i n g   r e m o v e d   t h e

freshly cleaned washing, leave
t h e   d o o r   o p e n   t o   a l l o w   a i r
circulation inside the drum.
Always disconnect electricity at
the socket and turn off the water
supply.

Remember that, in the event
of a power failure, or should
the washing machine switch
i t s e l f   o f f , t h e   p r o g r a m m e
c h o s e n   w i l l   r e m a i n   i n   i t s
memory.

The labels say it all.

Always look at the labels: they
tell you everything about your
garment and how to wash it in
the best possible way.
The table on page 17 shows all
m e a n i n g s   b e h i n d   t h e s e
s y m b o l s .  T h e i r   r e c o m -
mendations are impor tant to
achieve better wash results.

Instructions for installation and use

14

M

Big and small happily
together.

This washing machine has a
special electronic control device
for even distribution: before the
spin cycle star ts, this device
allows the garments to positions
themselves, to minimise noise
and vibrations during the spin
cycle.