Indesit PWSE 6128S - Инструкция по эксплуатации - Страница 3

3

GB

Connecting the drain hose

Connect the drain hose, 
without bending it, to a 
drain duct or a wall drain 
situated between 65 and 
100 cm from the floor;

alternatively, place it over 
the edge of a basin, sink 
or tub, fastening the duct 
supplied to the tap (

see 

figure

). The free end of 

the hose should not be 
underwater.

!

 We advise against the use of hose extensions; if it is 

absolutely necessary, the extension must have the same 
diameter as the original hose and must not exceed 150 cm 
in length.

Electrical connections

Before plugging the appliance into the electricity socket, 
make sure that: 
•  the socket is earthed and complies with all applicable 
laws;

•  the socket is able to withstand the maximum power 
load of the appliance as indicated in the Technical data 
table

 (see opposite);

•  the power supply voltage falls within the values 
indicated in the Technical data table (

see opposite

);

•  the socket is compatible with the plug of the washing 
machine. If this is not the case, replace the socket or the 
plug.

!

 The washing machine must not be installed outdoors, 

even in covered areas. It is extremely dangerous to leave 
the appliance exposed to rain, storms and other weather 
conditions.

!

 When the washing machine has been installed, the 

electricity socket must remain within easy reach. 

!

 Do not use extension cords or multiple sockets.

65 - 100 cm

!

 The cable should not be bent or compressed.

!

 The power supply cable must only be replaced by 

authorised technicians.

Warning! The company shall not be held responsible in the 
event that these standards are not observed.

The first wash cycle

Once the appliance has been installed, and before you use 
it for the first time, run a wash cycle with detergent and no 
laundry, using wash cycle number 

2

.

Technical data

Model

PWSE 6128 S

Dimensions

width 59.5 cm
height 85 cm
depth 44,5 cm

Capacity

from 1 to 6 kg 

Electrical 
connections

please refer to the technical data plate 
fixed to the machine

Water connections

maximum pressure 1 MPa (10 bar)
minimum pressure 0.05 MPa (0.5 bar)
drum capacity 40 litres

Spin speed

up to 1200 rotations per minute

Energy rated 
programmes 
according to 
regulation 
EN 60456

programme 2; temperature 60°C;
using a load of 6 kg.

This appliance conforms to the following 
EC Directives:
- 89/336/EEC dated 03/05/89 (Electro-
magnetic Compatibility) and subsequent 
modifications
- 2006/95/EC (Low Voltage)
- 2002/96/EC