STATUS CBL 16-2Li 07126001 - Инструкция по эксплуатации - Страница 6

6

EN

KNOW YOUR PRODUCT

OPERATION

KNOW YOUR PRODUCT

OPERATION

CHARGING BATTERY PACK (Fig. 3)

FITTING AND REMOVING THEBATTERY PACK 

To remove the battery: Press release button (4) in the indicated direction (A) and pull the 

battery out of the machine body. (B) 

• 

To use this tool properly, you must observe the safety regulations, the assembly 

instructions and the operating instructions to be found in this Manual. All persons 

who use and service the machine have to be acquainted with this Manual and must be 

informed about its potential hazards. Children and frail people must not use this tool. 

Children should be supervised at all times if they are in the area in which the tool is 

being used. It is also imperative that you observe the accident prevention regulations 

in force in your area. The same applies for general rules of occupational health and 

safety.

• 

The manufacturer shall not be liable for any changes made to the tool nor for any 

damage resulting from such changes. 

Even when the tool is used as prescribed it is not possible to eliminate all residual risk 

factors. The following hazards may arise in connection with the tool’s construction and 

design:

• 

Damage to the lungs if an effective dust mask is not worn.

• 

Damage to hearing if effective ear defenders are notworn.

• 

Power tools must not be used outdoors in rainy weather, or in moist environment (after 

rain) or in close vicinity with easily flammable liquids and gases. The working place 

should be well lit.

1.  Keyless chuck

2.  Speed selector switch

3.  Forward/reverse switch

4.  Battery release button

5.  Battery

6.  ON/OFF trigger switch

7.  Battery state indicator

8.  LED light

9.  Torque adjustment collar

10.  Charger

Ligts

Status

Green on

Plugged in / Fully charged

Red on

Charging in progress