Ryobi ONE+ с набором бит RAK17SD R18PD-LL25T 5133002454 - Инструкция по эксплуатации - Страница 3

English

1

EN

FR

DE

ES

IT

NL

PT

DA

SV

FI

NO

RU

PL

CS

HU

RO

LV

LT

ET

HR

SL

SK

EL

TR

UK

Safety, performance, and dependability have been given 
top priority in the design of your percussion drill.

INTENDED USE

The percussion drill is intended to be used only by adults 
who have read and understood the instructions and 
warnings in this manual, and can be considered responsible 
for their actions. 

The percussion drill is intended to be used in drilling into 
various materials, including wood, metal, and plastic using 
a drill bit having a diameter of less than 13 mm. When in 
impact mode, the percussion drill can be used in drilling 
masonry and similar materials. When in screwdriving 
mode, the percussion drill can be used in driving screws.

Do not use the product in any way other than those stated 
for intended use.

 WARNING

Read all safety warnings and all instructions.

 Failure 

to follow the warnings and instructions may result in 
electric shock, 

fi

 re and/or serious injury.

Save all warnings and instructions for future reference

.

PERCUSSION DRILL SAFETY WARNINGS

■

Wear ear protectors when impact drilling. 

Exposure 

to noise can cause hearing loss.

■

Use auxiliary handle(s), if supplied with the tool. 

Loss of control can cause personal injury.

■

Hold power tool by insulated gripping surfaces 
when performing an operation where the cutting 
accessory may contact hidden wiring. 

Cutting 

accessory contacting a “live” wire may make exposed 
metal parts of the power tool “live” and could give the 
operator an electric shock.

■

Hold power tool by insulated gripping surfaces, 
when performing an operation where the fastener 
may contact hidden wiring.

 Fasteners contacting a 

“live” wire may make exposed metal parts of the power 
tool “live” and could give the operator an electric shock.

■

Do not operate on materials (e.g., asbestos) that 
present a health hazard.

■

Switch off the product immediately if the bit stalls. Do 
not switch on the product again while the bit is stalled, 
as doing so could trigger a sudden recoil with a high 
reactive force. Determine why the bit stalled and rectify 
this, paying heed to the safety instructions.
The possible causes may be:

–

it is tilted in the workpiece

–

it has pierced the workpiece

–

the product is overloaded

■

Sawdust and splinters must not be removed while the 
product is running.

■

When working in walls, ceilings, or floors, avoid 
electrical cables and gas or water pipes.

■

Secure your workpiece with a clamping device.

TRANSPORTING LITHIUM BATTERIES

Transport the battery in accordance with local and national 
provisions and regulations.

Follow all special requirements on packaging and labelling 
when transporting batteries by a third party. Ensure that 
no batteries can come in contact with other batteries 
or conductive materials while in transport by protecting 
exposed connectors with insulating, non-conductive caps 
or tape. Do not transport batteries that are cracked or 
leaking. Check with the forwarding company for further 
advice.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still 
impossible to completely eliminate certain residual risk 
factors. The operator should pay particular and additional 
attention to these points in order to reduce the risk of 
serious personal injury.

■

Injury to hearing

NOTE:

 Wear suitable ear protection and limit exposure.

■

Injury to sight

NOTE: 

Wear protective eye shields or goggles when 

using the product.

■

Injury caused by vibration 

NOTE: 

Limit exposure and follow the instructions on 

risk reduction in this manual.

■

Electric shock after contact with hidden wires 

NOTE: 

Hold the product only by insulated surfaces.

■

Respiratory injury from dust created by operating the 
product 

NOTE: 

Wear suitable protection depending on type of 

dust.

RISK REDUCTION

It has been reported that vibrations from handheld tools 
may contribute to a condition called Raynaud’s Syndrome 
in certain individuals. Symptoms may include tingling, 
numbness and blanching of the 

fi

 ngers, usually apparent