HITACHI DV14DCL2 - Инструкция по эксплуатации - Страница 15

English

13

2. Inspecting the mounting screws

Regularly inspect all mounting screws and ensure
that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure
to do so could result in serious hazard.

3. Maintenance of the motor

The motor unit winding is the very “heart” of the
power tool.
Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.

4. Cleaning on the outside

When the Impact driver drill is stained, wipe with
a soft dry cloth or a cloth moistened with soapy
water. Do not use chloric solvents, gasoline or paint
thinner, for they melt plastics.

5. Storage

Store the Impact driver drill in a place in which the
temperature is less than 40°C and out of reach of
children.

6. Service parts list
CAUTION

Repair, modification and inspection of Hitachi Power
Tools must be carried out by a Hitachi Authorized
Service Center.
This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance.
In the operation and maintenance of power tools,
the safety regulations and standards prescribed in
each country must be observed.

MODIFICATIONS

Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.

Important notice on the batteries for the Hitachi
cordless power tools

Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when
used with batteries other than these designated
by us, or when the battery is disassembled and
modified (such as disassembly and replacement
of cells or other internal parts).

GUARANTEE

We guarantee Hitachi Power Tools in accordance with
statutory/country specific regulation. This guarantee
does not cover defects or damage due to misuse,
abuse, or normal wear and tear. In case of complaint,
please send the Power Tool, undismantled, with the
GUARANTEE CERTIFICATE found at the end of this
Handling instruction, to a Hitachi Authorized Service
Center.

NOTE

Due to HITACHI’s continuing program of research and
development, the specifications herein are subject to
change without prior notice.

Information concerning airborne noise and vibration

The measured values were determined according to
EN60745 and declared in accordance with ISO 4871.

Measured A-weighted sound power level: 96 dB (A)
Measured A-weighted sound pressure level: 85 dB (A)
Uncertainty KpA: 3 dB (A).

Wear hearing protection.

Vibration total values (triax vector sum) determined
according to EN60745.

Impact drilling into concrete:
Vibration emission value 

a

h

, 

  ID

  = 13.5 m/s

2

Uncertainty K = 2.4 m/s

2

Drilling into metal:
Vibration emission value 

a

h

, 

D

  = 2.4 m/s

2

Uncertainty K = 1.5 m/s

2

WARNING

䡬

The vibration emission value during actual use of
the power tool can differ from the declared value
depending on the ways in which the tool is used.

䡬

To identify the safety measures to protect the
operator that are based on an estimation of exposure
in the actual conditions of use (taking account of
all parts of the operating cycle such as the times
when the tool is switched off and when it is running
idle in addition to the trigger time).