FERM PMM1010 - Инструкция по эксплуатации - Страница 5

5

EN

d)  

Under abusive conditions, liquid may be 
ejected from the battery; avoid contact. 

If contact accidentally occurs, flush with 

water. If liquid contacts eyes, additionally 
seek medical help

. 

Liquid ejected from the 

battery may cause irritation or burns.

6)   Service

a)  

Have your power tool serviced by a 

qualified repair person using only identical 

replacement parts. 

This will ensure that the 

safety of the power tool is maintained.

SPECIFIC SAFETY INSTRUCTIONS

• 

Firmly tighten the mixing paddle, and 
remove the spanner before starting the 
machine.

• 

Do not use the power tool for explosive 
materials (e. g., easily inflammable 
solvents).

 Power tools produce sparks which 

could ignite developing vapours.

• 

In case the power tool should fall into 
the material to be stirred, pull the plug 
immediately and have the power tool 
checked by an after-sales service agent.

Material that has penetrated the power tool can 
cause damage and lead to an electric shock.

• 

Hold the machine firmly with both hands 
by the insulated gripping surfaces while 
working and keep proper footing and 
balance at all times.

 The machine is more 

securely guided with both hands. Loss of 
control can cause personal injury.

• 

Hold power tool by insulated gripping 
surfaces, when performing an operation 
where the accessory may contact hidden 
wiring or its own cord.

 The accessory 

contacting a “live” wire may make exposed 
metal parts of the power tool “live” and could 
give the operator an electric shock.

• 

Switch off the power tool immediately 
when the tool insert jams. Be prepared 
for high reaction torque that can cause 
kickback.

 The tool insert jams when:

  —  the power tool is subject to overload or
  —  it becomes wedged in the workpiece.
• 

Do not mix food.

 Power tools and their 

accessories are not designed for processing 
food.

• 

Keep the cord away from the working area.

The cord may be entangled by the stirrer whisk.

• 

The mixing container must be suitable for 
mixing and must stand securely.

 A container 

that is not properly secured may move 
uncontrolled.

• 

Ensure that no liquid splashes against the 
housing of the power tool.

 Liquid that has 

penetrated the power tool can cause damage 
and lead to electric shock.

• 

Follow the instructions and warnings in the 
Material Safety Data Sheets (MSDS) of the 
material to be mixed.

 Material to be mixed 

may be harmful.

• 

In the event of a power interruption, 
release the locking switch by pressing the 
on/off switch.

 This will prevent the power tool 

from restarting unintentionally (risk of injury).

• 

Do not use the power tool in a stand.

Electrical safety

When using electric machines always observe the 
safety regulations applicable in your country to 
reduce the risk of fire, electric shock and personal 
injury. Read the following safety instructions and 
also the enclosed safety instructions.

Always check that the power supply 
corresponds to the voltage on the rating 
plate.

Mains connection

Only use earthed sockets with earthing wire 
connected per the regulations.

Using extension cables

Only use an approved extension cable, 
corresponding to the machine power use. The 
wires must have a minimum cross section of 1.5 
mm

2

. If the cable is on a reel, it must be fully laid 

out.

2.  MACHINE INFORMATION

Intended use

The machine is intended for mixing pulverised 
building materials such as mortar, plaster, 
adhesives, as well as solvent free paint, varnish 
and similar substances. Improper use may 
damage the tool.