Worx WX801 - Инструкция по эксплуатации - Страница 9

9

EN

“live” and could give the operator an electric shock.

k)   Never lay the power tool down until the accessory has come to a 

complete stop. 

The spinning accessory may grab the surface and pull the power 

tool out of your control.

l)   Do not run the power tool while carrying it at your side. 

Accidental 

contact with the spinning accessory could snag your clothing, pulling the accessory into 

your body.

m)   Regularly clean the power tool’s air vents. 

The motor’s fan will draw the 

dust inside the housing and excessive accumulation of powdered metal may cause 

electrical hazards.

n)   Do not operate the power tool near flammable materials. 

Sparks could ignite 

these materials.

o)   Do not use accessories that require liquid coolants. 

Using water or other 

liquid coolants may result in electrocution or shock.

p)   Your hand must hold on the handle when you are working. Always use the auxiliary 

handles supplied with the tool. Loss of control can cause personal injury.

FURTHER SAFETY INSTRUCTIONS FOR ALL 

OPERATIONS

KICKBACK AND RELATED WARNINGS

Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, 

brush or any other accessory. Pinching or snagging causes rapid stalling of the 

rotating accessory which in turn causes the uncontrolled power tool to be forced in 

the direction opposite of the accessory’s rotation at the point of the binding.

For example, if an abrasive wheel is snagged or pinched by the workpiece, the 

edge of the wheel that is entering into the pinch point can dig into the surface 

of the material causing the wheel to climb out or kick out. The wheel may either 

jump toward or away from the operator, depending on direction of the wheel’s 

movement at the point of pinching. Abrasive wheels may also break under these 

conditions.

Kickback is the result of power tool misuse and/or incorrect operating procedures or 

conditions and can be avoided by taking proper precautions as given below.

a)  Maintain a firm grip on the power tool and position your body and arm 

to allow you to resist kickback forces. Always use auxiliary handle, 

if provided, for maximum control over kickback or torque reaction 

during start-up.

 The operator can control torque reactions or kickback forces, if proper 

precautions are taken.

b)   Never place your hand near the rotating accessory. 

Accessory may kickback 

over your hand.

c)  Do not position your body in the area where power tool will move if 

kickback occurs. 

Kickback will propel the tool in direction opposite to the wheel’s 

movement at the point of snagging.

d)   Use special care when working corners, sharp edges etc. Avoid 

bouncing and snagging the accessory. 

Corners, sharp edges or bouncing have 

a tendency to snag the rotating accessory and cause loss of control or kickback.

e)   Do not attach a saw chain woodcarving blade or toothed saw blade.

Such blades create frequent kickback and loss of control.