Ryobi EBS800V (5133001146) - Инструкция по эксплуатации - Страница 3

English

1

EN

FR

DE

ES

IT

NL

PT

DA

SV

FI

NO

RU

PL

CS

HU

RO

LV

LT

ET

HR

SL

SK

EL

TR

SPECIAL SAFETY RULES

■

Hold power tool by insulated gripping surfaces, 
because the belt may contact its own cord.

 Cutting a 

“live” wire may make exposed metal parts of the power 
tool “live” and could give the operator an electric shock.

■

Always wear safety goggles and a dust mask when 
sanding, especially sanding overhead.

■

A suitable breathing respirator must be worn while 
sanding lead paint, some woods and metal to avoid 
breathing the harmful/toxic dust or air.

■

The machine is not suitable for wet sanding.

■

Do not use sanding belt larger than needed.

 WARNING

Do not throw sanding dust on an open fire

 because 

materials in 

fi

 ne particle form may be explosive.

 WARNING

If the replacement of the supply cord is necessary, this 
has to be done by the manufacturer or his agent in order 
to avoid a safety hazard.

INTENDED USE

You may use this product for the purposes listed below:

■

Sanding on wood surfaces.

■

Removing rust from and sanding steel surfaces.

MAINTENANCE

 WARNING

The tool should never be connected to a power supply 
when you are assembling parts, making adjustments, 
cleaning, performing maintenance, or when the tool is 
not in use. Disconnecting the tool will prevent accidental 
starting that could cause serious injury.

 WARNING

When servicing use only identical Ryobi replacement 
parts. Use of any other parts may create a hazard or 
cause product damage.

GENERAL

Avoid using solvents when cleaning plastic parts. Most 
plastics are susceptible to various types of commercial 
solvents and may be damaged by their use. Use clean 
cloths to remove dirt, carbon dust, etc.

 WARNING

Do not at any time let brake 

fl

 uids, gasoline, petroleum-

based products, penetrating oils, etc. come in contact 
with plastic parts. They contain chemicals that can 
damage, weaken or destroy plastic.

Electric tools used on 

fi

 berglass material, wallboard, 

spackling compounds, or plaster are subject to accelerated 
wear and possible premature failure because the 

fi

 berglass 

chips and grindings are highly abrasive to bearings, 
brushes, commutators, etc. Consequently, we do not 
recommend using this tool for extended work on these 
types of materials. However, if you do work with any of 
these materials, it is extremely important to clean the tool 
using compressed air.

 WARNING

Always wear safety goggles or safety glasses with side 
shields during power tool operation or when blowing 
dust. If operation is dusty, also wear a dust mask.

LUBRICATION

All of the bearings in this tool are lubricated with a suf

fi

 cient 

amount of high grade lubricant for the life of the unit 
under normal operating conditions. Therefore, no further 
lubrication is required.

CLEANING THE SANDING BELT

The sanding belt that came with your sander is made to 
be re-used. Therefore, it is important that it be cleaned 
periodically to remove sanding residue and foreign material 
that can accumulate over time. One of the ways to clean 
sanding belt is to rub the sheets with a hard rubber block. 
You can also use the clean rubber sole of a shoe.

 WARNING

Always remove the sanding belt from sander before 
cleaning. Failure to do so could cause serious personal 
injury.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing 
of as waste. The machine, accessories 
and packaging should be sorted for 
environmental-friendly recycling.

SYMBOL

Safety Alert

V

Volts