Vitek VT-2538 - Инструкция по эксплуатации - Страница 6

6

 ENGLISH

• 

Use the unit only on healthy undyed and not permed 

hair or use it along with special hair straightening 

products.

• 

If your hair has been dyed or permed, use the unit rarely.

• 

For the best results the hair should be clean and dry.

• 

Put the unit on a flat steady and heat-resistant surface.

• 

Insert the plug into the socket, switch the unit on by set-

ting the power switch (3) to the position «I», the power 

indicator (2) will light up.

Note:

 During the first operation some smell from the heat-

ing element is possible, this is normal.

• 

Let the unit heat up.

• 

Divide combed hair into locks of equal width (about 5 cm).

• 

Place the hair lock between the plates (1).

• 

Hold the unit by its handle (4).

• 

Press a lock of hair between the heating plates (1) near 

the hair roots, press the plates together and create curls 

throughout the hair length. 

• 

Do not slide the unit throughout the hair lock length, 

just press the heating plates (1) together to crimp hair.

IMPORTANT:

 under no circumstance let the plates remain 

in the same area of the hair lock for more than 2-3 seconds.

• 

After that start styling the next hair lock.

• 

Cool your hair down before final styling or applying hair 

spray.

• 

Avoid contact of heated surfaces with your face, neck 

and other parts of your body.

• 

After use set the power switch (3) to the position «O», 

the indicator (2) will go out; then take the power plug 

out of the socket. Let the unit cool down.

Note:

–  Always switch the unit off and unplug it if it is not used.

–  Never leave the unit connected to the mains unattended.

CLEANING AND CARE

• 

Before cleaning, unplug the unit and let it cool down 

completely.

• 

Never immerse the unit into water or any other liquids.

• 

Wipe the unit body with a soft, slightly damp cloth and 

then wipe the unit body dry.

• 

Do not use abrasives and solvents to clean the unit.

IM VT-2538_70x130.indd   6

7/23/19   6:56 PM