Remington S8670 E51 - Инструкция по эксплуатации - Страница 4

ENGLISH

2

 TO CHANGE THE STRAIGHTENING/CRIMPING PLATES

 • 

Ensure the unit is switched of f and cool.

 • 

Slide the plates out holding the plastic edges.

 • 

Turn the plates over and slot back into place.

 TO SECURE ATTACHMENT TO HANDLE

 • 

Ensure the locking ring is in the unlocked position, ready to inser t the at tachment . 
Locate the pins on the at tachment and holes on the handle. ( DIAGR AM 1)

 • 

Firmly push together. ( DIAGR AM 2 )

 • 

Turn the locking ring anti-clockwise to secure the handle and the attachment together, 
while still pressing down on the attachment (DIAGR AM 3).

Plug in the unit and switch on, the first green LED indicator light will star t flashing. 

NOTE :The unit will not turn on unless the at tachment is inser ted correctly.

Select the desired temperature. To change the temperature, use the ‘+’ or ‘-’ but tons 
to increase or decrease the temperature. The LED lights will flash until your desired 
temperature has been reached. Af ter use switch the unit of f.

For finer hair t ypes a lower temperature is recommended.

IMPORTANT INSTRUCTIONS

Due to the extreme heat capabilities of this st yler, extra care should be taken when 
using.

While heating, during use and cooling, place on flat , smooth, heat-resistant sur face. Only 
hold unit at the end of the handle.

Please note regular use of st yling products may deteriorate the coating. 

Do not scratch the sur face, as this will deteriorate the ef fectiveness of the coating.

CLEANING AND  MAINTENANCE

Ensure the unit is unplug ged and cool. Wipe clean any build up of st yling products with a 
damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.

SAFETY CAUTIONS

WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION OF
A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL 
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN 
ELECTRICIAN FOR ADVICE.

100201_REM_IFU_S8670_21L.indd   GB_2

100201_REM_IFU_S8670_21L.indd   GB_2

30.03.10   21:50

30.03.10   21:50