Роботы-пылесосы Tefal RG8021RH Smart Force Cyclonic Connect - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
10
• Your appliance stops during use:
- Your appliance may be overheating.
4
Stop the appliance and leave cool for at least 1 hour.
4
If it overheats on repeated occasions, contact the Approved Services Centre.
• The appliance stopped after the charge light was flashing:
- The appliance has run out of battery charge.
4
Recharge the vacuum cleaner.
• The power-brush is not working properly or makes a noise:
- The rotating brush or hose are obstructed.
4
Stop the vacuum cleaner and clean them.
- The brush is worn.
4
Contact an Approved Service Centre to change the brush.
- The belt is worn.
4
Contact an Approved Service Centre to change the belt.
• The power-brush stops during vacuuming:
- The safety function has been triggered.
4
Stop the vacuum cleaner. Check that nothing is obstructing the rotation of the brush; if there is an
obstruction, remove it and clean the power-brush, then turn on the vacuum cleaner.
• Your vacuum cleaner is not vacuuming as well, is making noise, whistling:
- The intake channel is partially blocked.
4
Unblock it
- The dust collector is full.
Empty it and clean it.
- The dust collector is not properly fitted.
4
Re-position it correctly.
- The intake head is clogged.
4
Remove the power-brush and clean it.
- The protective foam filter is saturated.
4
Clean it.
According to model: *
Display
Description of the error
Possible cause/solution
ERR1
The left wheel is jammed/blocked.
Remove the obstruction.
ERR2
The right wheel is jammed/blocked.
ERR3
The power-brush is jammed/blocked.
ERR4
The power-brush motor has over-
loaded.
Turn off the appliance and wait at least 30 minutes be-
fore switching it back on and using it.
ERR8
Malfunction of the detection wheel
under the robot.
Remove any element which is blocking the robot or free
the robot if it is stuck.
ERR9
The front and back sensors are not
making contact with the floor.
Lift the appliance and place it somewhere else on the
floor.
ERR10
The dust collector and filter are not cor-
rectly positioned in their housing.
The dust collector and filter are not in
the appliance.
Open the housing and correct the position of the dust
collector and filter.
Place the dust collector and filter inside the appliance.
ERR11
The bumper is jammed or faulty.
Free the appliance if it has become stuck against an obs-
tacle. If necessary, apply light pressure to the bumper
to free it.
ERR12
The internal clock has malfunctioned.
Turn off and re-start the appliance.
If the problem persists, contact Customer Service.
ERR13
A failure in the function of the driving
wheels.
Free the robot if it is stuck. If necessary, remove the ob-
struction to the wheels.
