Telefunken TF-1596 - Инструкция по эксплуатации - Страница 4

Instruction manual

3

Important safeguards

•

The instruction manual contains important

operating and maintenance instructions. For 
your safety, it is necessary to refer to the 
manual. Keep the manual for future use.

• Do not hit or drop the unit
• Do not

 e

xpose the unit to vibration, direct

sunlight, too high or low temperatures or 
humidity.

• Do not disassemble the unit yourselves

Refer servicing to qualified service personnel

All the illustrations in this manual are 

schematic images, which may differ from 
actual objects.

Power supply

Battery operation

• Insert 

1

CR2032

 batter

y

(

included)

to the terminals inside the battery 
compartment according to the polarity marks 
(+ and -). Your set will have a limited 
operation from the battery supply, but there is 
now the advantage that, in case of a mains 
current failure or power outage, your clock will 
continue to work. The clock display will not 
light up, the clock time and alarm setting will 
be held in the clock memory by the battery 
back-up system.

This enables you to move the set from place 

to place without re-setting the clock every time. 
The battery back-up system is only meant to 
be used for short-term power failures. For 
longer durations the batter

y

 may become 

exhausted or there may be some deviation in 
accuracy.

•

When the batter

y

is

 exhausted, 

it

check that the voltage indicated on the rating 
label corresponds to the mains voltage in your 
location.

plug in the appliance for the first time and when 
there has been a power failure.

General operations

Setting time  

• You have to set the clock time when you

approximately 40-50 cm from your head, for 
example, on a bedside table.

Placement

• Place the device close to you,

should be removed from the set to prevent 
leakage. If you do not wish to take advantage 
of the battery back-up system, your set will 
work normally without batteries. However, if 
disconnected from the mains, the clock 
figures will flash when the mains are 
reconnected and you must re-set the clock.

DС operation

• The appliance is for household use only.
• Before the first connecting of the appliance

• Plug the supplied AC/DC power

adaptor into the DC adaptor input on the back 
of the unit. Connect the power cord to the AC 
household main outlet. Make sure the voltage 
is compatible.

• Always remember to disconnect

the  power  cord  from  the  main  supply  before 
disconnecting it from the unit.

• When the time starts to blink touch

           to adjust it. Touch       to confirm. Setting 
will be canceled if no button is pressed in 

10

 seconds.

modes by pressing      . When the 12-hour 
format is selected, AM or PM will be displayed.

• Choose between a 12-hour and 24-hour

time display: Low - High - Off.

• Press     to adjust the brightness of 

automatically change to high brightness 
when you change any settings, and then 
revert back to low intensity after 5 seconds.

• When 

low brightness is selected, it will

Light

•

Press

       once to switch on white  

light and use it as a bedside lamp. You can 
adjust the light intensity by touching

, 

there are 10 levels in total.

• Change current time by pressing and

holding       for 3 seconds until the time starts 
to blink. Touch            to adjust it. Touch       to 
confirm. Setting will be canceled if no button is 
pressed in 10 seconds.