Telefunken TF-1571 - Инструкция по эксплуатации - Страница 3

Instruction manual

3

Important safeguards

•

The instruction manual contains important

operating and maintenance instructions. For 
your safety, it is necessary to refer to the 
manual. Keep the manual for future use.

• Do not hit or drop the unit
• Do not

 e

xpose the unit to vibration, direct

sunlight, too high or low temperatures or 
humidity.

• Do not disassemble the unit yourselves

Refer servicing to qualified service personnel

All the illustrations in this manual are 

schematic images, which may differ from 
actual objects.

Power supply

Battery operation

•

Insert 2 АА (UM-

3

) batteries (not included)

to the terminals inside the battery compartment 

according to the polarity marks (+ and -). Your 

set will not work normally from the battery 

supply, but there is now the advantage that, in 

case of a mains current failure or power 

outage, your clock will continue to work. The 

clock display will not light up, the clock time 

and alarm setting will be held in the clock 

memory by the battery back-up system.

This enables you to move the set from place 

to place without re-setting the clock every 

time. The battery back-up system is only 

meant to be used for short-term power 

failures. For longer durations the batteries may 

become exhausted or there may be some 

deviation in accuracy.

• When the batteries are exhausted, they

should be removed from the set to prevent 

leakage. If you do not wish to take advantage 

of the battery back-up system, your set will 

work normally without batteries. However, if 

disconnected from the mains, the clock figures 

will flash when the mains are reconnected and 

you must re-set the clock.

A

С operation

• The appliance is for household use only.
• Before the first connecting of the appliance

check that the voltage indicated on the rating 
label corresponds to the mains voltage in your 
location.

• Insert the plug into the electrical outlet.
• The set is now working as an electronic

clock.

(radio is off), press and hold the TIME button. The 

time will start to flash.

General operations

Setting the clock 

•

When the unit is in standby mode

to increase the HOUR. 

•

Press the 

PREVIOUS

 button

TIME button again to confirm.

•

Press the 

NEXT

 button

to increase the 

MINUTES.

•

Once time is set correctly, press the

Setting the alarm

•

When the unit is in standby mode

(radio off), quickly press either AL1 or AL2 buttons.

The alarm LED will start to flash

 and show "OFF".

between the 

BB

 and radio alarm signals. Press 

AL1/AL2 to confirm, or 

TIME

 to select a different 

radio station. Press AL1/AL2 to confirm.

• Press the 

PREV

/

NEXT

 buttons to select

to adjust the alarm time. 

Use the PREV/NEXT 

buttons to select the hour and the minute

. 

If it is 

with FM radio as ringtone, before the LED twinnkle 

three times, quick press station selection button 

(8)

to select the station which you would like to be

as ringtone, then set the hour and minute same

way, after that, the "V00" on the LED will twinkle,

you can set the volume level by pressing PRE/

NEXT at last press AL1 or AL2 again to complete

alarm setting.

•

Press and hold the AL1 or AL2 buttons

Snooze control

• When the alarm time comes, the signal will

sound  for 

59

  minutes  if  no  button  is  pressed. 

After that the sound will mute and start at the 

same time the following day.

Press and hold this button to turn the unit off.

Turning On and Off

•

Press 

the

/M 

button

 to turn the unit on

.

time display by double pressing the TIME button.

•

You can switch between 12 and 24 hour