Радиоприемники Telefunken TF-1566U - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Instruction manual
5
5
Radio operation
• Set the function switch to RADIO
position; the current radio frequency
will be displayed for several seconds,
then clock will be displayed.
• Press repeatedly
/TUN- and
/TUN+ buttons on the unit (
/
TUNING and
/TUNING buttons
on the RC) to change the current
frequency downwards or upwards by
100 KHz.
• Press and hold
/TUN- and
/TUN+ (
/TUNING and
/TUNING)
buttons to search the nearest strong
signal station downwards or upwards
automatically.
• Press MEMORY button on the
RC ( /MEMO/USB/SD button on the
unit); C01 will blink. Press repeatedly
TIME SET/MEM-UP/12H/24H or
ALARM.SET/MEM-DN buttons on the
unit to select the position number for
the current frequency. Press MEMORY
( /MEMO/USB/SD) button to save the
frequency in the position (1~30).
• Press and hold MEMORY ( /
MEMO/USB/SD) button; it will start
scanning from the lowest frequency
and automatically save all available
stations in positions (up to 30).
• When stations are saved in the
memory, press repeatedly TIME SET/
MEM-UP/12H/24H or ALARM.SET/
MEM-DN buttons on the unit or number
buttons on the RC to select saved
stations.
• In radio mode, press SNOOZE
button; the display will show the current
frequency for 10 seconds, then return
to clock.
• Rotate VOLUME regulator to
adjust the sound volume level. Press
MUTE button on the RC to switch off
the sound; the digits on the display
will blink. Press MUTE button again to
enable the sound.
• Extend the FM antenna for a
better signal reception.
Alarm operation
Setting the alarm
• Set the function switch to MODE
position.
• Press and hold ALARM button on
the RC (ALARM.SET/MEM-DN button
on the unit) until the digits flash. AL1
indicator will be blinking showing that
the 1st alarm is being set.
• Press repeatedly
/TUN- and
/TUN+ buttons on the unit (
/
TUNING and
/TUNING buttons on
the RC) to set hours of the 1st alarm
(AL1). Press ALARM (ALARM.SET/
MEM-DN) button to save hours; minute
digits will flash. Press repeatedly
/
TUN- and
/TUN+ (
/TUNING and
/TUNING) buttons to set hours of
the 1st alarm. Press ALARM (ALARM.
SET/MEM-DN) button to save minutes;
the unit is in the signal sound selection
