Xiaomi Vacuum Cleaner G9 BHR4368GL - Инструкция по эксплуатации - Страница 9

14

15

1. Insert the cyclone assembly vertically into the dust 
compartment, and make sure that the handle of the cyclone 
assembly line up with the slot on the left side of the dust 
compartment. Turn the handle clockwise until it locks, then flip 
the handle down.

3. Slightly tilt the dust compartment so its slot aligns with the clip 
on the vacuum cleaner. Then gently push the dust compartment 
until it clicks into place.

2. Place the pre-filter with its front side facing up into the cyclone 
assembly.

Installing the Dust Compar tment, Pre-f ilter, and 

Cyclone Assembly

1

2

Insert until 
it clicks into 
place

2. Remove the HEPA filter from the vacuum cleaner by pulling it 
down in the direction shown in the figure.

Cleaning the HEPA Filter

1. Remove the dust compartment as shown in the figure.

Note: It is recommended to clean the HEPA filter once every 4 
to 6 months.

3. Clean the HEPA filter with clean water. Make sure you rotate the 
HEPA filter 360° to thoroughly remove all dust caught in the filter. 
Lightly tap the filter several times to remove any excess dirt.

Notes:

Only use clean water to clean the filter. Do not use detergent.
Do not attempt to clean the HEPA filter with a brush or finger.

Care & Maintenance

2

1

Pre-filter

1

2

Dust Compartment Release Switch