Tefal Silence Force 4A TW7681EA - Инструкция по эксплуатации - Страница 9

6

Instructions regarding the energy label

This is a general purpose vacuum cleaner. 

To achieve energy efficiency and the cleaning performance category indicated on carpets, please use the dual/triple 

position vacuum head, with the brush retracted ( depending on the model, 

 or 

*). 

To achieve energy efficiency and cleaning performance category indicated on hard floors with joints and groo-

ves, please use :

•  The Softcare+ nozzle for smooth floors with grooves* (a) without the removable brush.

•  Only if there is no Softcare+ nozzle included, please use the dual/triple position va-

cuum head* with the brush retracted, not equipped with the additional accessory*(pro-

vided depending on the model).  (

*).

The data provided relating to the energy label was established using the measuring 

methods defined in the Directives 665/2013 of 3 May 2013 and 666/2013 of 8 July 

2013.

For delicate smooth floorings, such as parquet, laminated flooring or tiles, it is recommended to use either :

•  The nozzle for smooth floors with grooves*, with the brush retracted (a+b). 

•  The dual/triple position vacuum head*, with the brush extended (

*).

REPAIR SERVICE

Repairs should only be performed by specialists using original spare parts. 

If a problem persists, take your vacuum cleaner to your nearest Approved Service Centre or contact Customer Services.

If your vacuum cleaner does not function :

•  Check that the appliance is plugged in correctly.

If the suction attachment is difficult to move :

•  Reduce the power by opening the mechanical power control on the butt or by moving the electronic power 

control switch towards the MIN position. 

•  Make sure that the position of the nozzle corresponds to the floor being vacuumed : 

- for rugs and carpets, use the nozzle in the retracted brush position, 

- for parquets and smooth floors, use the nozzle in the advanced position. 

If the power cord does not wind up completely :

•  The power cord is slow to wind up: pull the cord out again and press on the power cord rewind pedal.

If your vacuum cleaner stops during use :

•  The safety mechanism was triggered. Check the tube and hose for blockage. Check if the bag and filters are 

saturated. Leave 30 minutes to cool down before switching the vacuum cleaner on again. 

Vacuum cleaners with bag

If your vacuum cleaner suction is not working properly or is making a whistling noise :

•  There is a partial blockage in an accessory or in the hose: unblock the accessory or hose.

•  The bag is full or saturated with fine dust: replace the bag* or empty the textile bag*.

•  The lid is not properly closed: check the placement of the bag, of the dust bag holder and of the EPA filter 

casket and close the lid.

•  The filters are saturated: clean or change the filtration system EPA casket*, washable EPA filter casket*, micro-

filter casket*. See supplementary instruction manual).

If the change bag warning light is red :

•  The bag is saturated: replace the bag or empty the textile bag*. 

•  If the warning light remains red after the bag has been replaced: the filtration system is saturated (see supple-

mentary instruction manual) 

If the lid does not close :

•  Check to see if there is a bag and a dust bag holder in place and make sure they are well positioned. 

IMPORTANT

 : If you notice that your vacuum cleaner is not operating as well, before 

carrying out any checks, switch it off using the ON/OFF pedal.

b

a

*

* Model dependent: these parts are specific to certain models or they are accessories that can be purchased separately.

EN