SENCOR SVC 190W - Инструкция по эксплуатации - Страница 6

EN-6

EN

Copyright © 2020, Fast ČR, a. s. 

Revision 05/2020

VACUUMING OF LIQUIDS AND WATER

This vacuum cleaner can also be used to vacuum liquids and water. If vacuuming liquids ensure that the 
vacuuming angle is approximately 45° so that water is not sucked in through the filter.

When vacuuming water it is necessary to maintain the maximum allowable level (as is marked by a line 
on the container).

Note:

When  pouring  out  the  water  from  the  container  hold  the  vacuum  cleaner,  if  possible,  with 
the suction nozzle pointing downwards so that water does not enter the motor and cause ir-
reparable damage.

REMOVAL OF DUST, CLEANING AND MAINTENANCE OF THE PRODUCT

Before cleaning the product turn it off and disconnect it from the power source. Press the button for 
releasing the filter cover. The filter cover will come away from the body of the product, and then take 
out the filter from the cover. Remove all dirty material from the cover.

Cleaning the filter: remove the dust and dirty material from the filter or shake it above a rubbish bin so 
that the dirty material does not fall our over the sides.
If necessary, wash the filter, you can use a weak soap solution and lukewarm water. Allow the filter to 
dry.

Note:

Before inserting the filter back into the product it must be completely dry.

We recommend cleaning the filter after every use. Attaching the cover: Insert the filter into the cover 
and place on the product.
To clean the product, do not use cleaning agents that cause abrasion, petrol or solvents, for cleaning we 
recommend a cloth moistened in a weak neutral detergent solution.
Before storing the product, thoroughly clean it and place in a dry location.

Problem 

Possible cause 

Possible solution

The product does not 
function

the product wasn't recharged 
before use 

connect the product to the power 
supply (recharge the batteries)

the rechargeable batteries are 
installed incorrectly 

contact a service centre

the product needs to be tuned 

contact a service centre

The product does not 
vacuum, or its power is 
too low

The filter cover for dirty mate-
rial is full 

Remove the dirty material from 
the filter cover

discharged batteries 

connect the product to the power 
supply (recharge the batteries)

Dirty material is coming 
out of the product 

The cover for dirty material 
is full

remove the dirty material from 
the filter/filter cover

Hand Vacuum Cleaner

SVC 190B / SVC 190W / SVC 190R