BRAYER BR4267 - Инструкция по эксплуатации - Страница 10

10 EN

SWITCHING THE VACUUM CLEANER ON
Attention! Only turn on the Vacuum Cleaner with the 

installed Dust Box (5) with the Mesh Filter (16) and 

HEPA Filter (17) installed into it.

•  During cleaning or when carrying the vacuum cleaner 

hold the unit by the handle (1).

•  For easy storing of the vacuum cleaner or the battery 

charging use the wall-mounted holder of the vacuum 

cleaner (13).

•  Press the Power Button (15) to turn on the Vacuum 

Cleaner - the Vacuum Cleaner will turn on in the Low 

Suction Power Mode; press the Power Button (15) 

again to turn the Vacuum Cleaner off (Fig. 8).

•  When using the Vacuum Cleaner, you can alternate 

between Suction Power Modes by pressing the 

Suction Power Setting Button (14).

• 

The Indicator (3) flashing during operation means that 

the Battery (12) needs to be charged.

CLEANING AND  CARE

Attention! 
Keep the Dust Box (5), Mesh Filter (16), and HEPA 

Filter (17) clean, the performance of the Vacuum 

Cleaner depends on it.

•  For best results, clean the Dust Box (5) after each use 

of the Vacuum Cleaner; perform a periodic cleaning of 

the Mesh Filter (16) and the HEPA Filter (17).

•  To remove dust and garbage, position the Dust Box 

(5) over a garbage bin, press the Lock (6) (Fig. 9) and 

open the Cover (7), remove the dust and garbage, 

close the Cover (7) so that it would trigger the Lower 

Cover Lock (6).

Cleaning the Dust Box

•  Remove any dust and garbage from the Dust Box (5), 

as indicated above, before cleaning.

•  Press and hold down the Lock (4) to remove the Dust 

Box (5) (Fig. 10).

•  Remove the Holder (18) from the Dust Box (5), detach 

the Mesh Filter (16) and the HEPA-Filter (17).

•  Wash the Mesh Filter (16) and HEPA Filter (17) under a 

warm jet of running water and let them dry. 

• 

Wash the dust bin flask (5) and dry.

•  Do not wash all removable parts in a dishwashing 

machine.

Note:

 before assembling the dust bin (5) make sure that 

all removable parts are clean and dry.

Assembling of the dust bin 

•  Install the Mesh Filter (16) onto the HEPA Filter (17), 

and install them onto the Holder (18).

•  Install the Holder (18) into the Dust Box (5) retort.

•  Reinstall the assembled Dust Box (5) so that the Lock 

(4) produces a clicking sound; make sure that the Dust 

Box (5) is properly secured (Fig. 11).