Karcher WD 3 Premium - Инструкция по эксплуатации - Страница 13

– 8

Recommendation:

 In order to vacuum the floor, attach 

the handle to the suction hose.

Illustration 



Connect the handle with the suction hose until it 
snaps in place.

Illustration 



To remove the handle from the suction hose, press 
the notch using your thumb and pull off the handle.

Note:

 Due to removing the handle, accessories can be 

directly attached to the suction hose. 

Recommendation:

 In order to vacuum the floor, attach 

the handle to the suction hose.

See position 13.

Illustration 



Put both suction tubes together and connect them 
with the handle.



For edges, joints, heaters and hard to reach loca-
tions.

Illustration 



Note:

 For vacuuming dry dirt or water off the floor - 

always work with the insert (brush strip and rubber 
lip) in the floor nozzle.

Illustration 



To connect the suction hose with an electric tool



Adapt the adapter to the connection diameter of the 
electric tool using a knife if necessary.

ATTENTION

Always work with an inserted cartridge filter during wet 
as well as dry vacuum cleaning!

Illustration 



Mount loose parts delivered with appliance prior to 
start-up.

Illustration 



Connect accessories.

Illustration 



Plug in the mains plug.

Illustration 



Turn on the machine.

ATTENTION

Check the filter for damage prior to installation and re-
place as necessary.
Work with a dry cartridge filter only!

Illustration 



Recommendation

: To vacuum fine dust, use the 

filter bag.

–

The filling level of the filter bag depends on the dirt 
that is sucked in. 

–

The filter bag needs to be replaced more frequently 
while sucking in fine dust, sand, etc.

–

Clogged filter bags can burst - therefore make sure 
to replace the filter bag in a timely manner!

ATTENTION

Vacuum cold ashes only when using a pre-filter.

Order no. basic design: 2.863-139.0, premium design: 
2.863-161.0.



For vacuuming up moisture or liquids pay attention 
to the correct floor nozzle insert and connect the 
corresponding accessories.

ATTENTION

Do not use a filter bag!

Note: 

If the container is full, a float closes the suction 

opening, and the appliance works at a higher speed. 
Switch off the appliance immediately, and empty the 
container.

Illustration 



Adapt the adapter to the connection diameter of the 
electric tool using a knife if necessary.



Connect the adapter to the handle of the suction 
hose and connect it to the electric tool connection.
Connect the mains plug of the electric power tool to 
the vacuum cleaner.

Illustration 



Switch the vacuum cleaner to

 Position II

 and start 

working.

Note:

 As soon as the electric tool is switched on, the 

suction turbine starts with a 0.5 second delay. If the 
electric tool is switched off, the suction turbine contin-
ues to run for approx. 5 seconds in order to vacuum up 
the remaining dirt in the suction hose.

Cleaning hard to reach locations or, where vacuuming 
is not possible, like leaves from a gravel bed.

Illustration 



Connect the suction hose to the blower connection, 
this will activate the blower function.



Turn off the appliance. 

Illustration 



Hook the floor nozzle into the parking position.

Removable handle

Suction tubes 2 x 0.5 m

Crevice nozzle

Floor nozzle

(with inserts)

Adapter

Operation

Before Startup

Start up

Dry vacuum cleaning

Information filter bag

Wet vacuum cleaning

Working with electrical power tools

Blowing function

Interrupting operation

13

EN