Miele SKRR3 Blizzard CX1 - Инструкция по эксплуатации - Страница 99

23

The suction power setting 



 will flash

in the vacuum cleaner display.



Press the ComfortClean button on
the vacuum cleaner for at least four
seconds.

The vacuum cleaner can continue to be
used in this way, but only at maximum
power.



Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.



Replace the battery with a new one,
making sure the polarity is correct.



Replace the cover and tighten the
screw back up again.



Dispose of the old battery in a muni-
cipal recycling facility.



Keep batteries out of the reach

of children.
A swallowed battery can cause injury
and even death. Even flat batteries
can still be dangerous. If you suspect
a child has swallowed a battery, seek
medical advice immediately*. Exam-
ine devices and make sure the bat-
tery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
* Australia: Poisons Information
Centre, Tel. 13 11 26;
NZ: National Poisons Centre,
Tel. 0800 764 766

When to change the thread lifters

(not possible on EcoTeQ Plus floor-
heads)

The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters



Use a suitable screwdriver to remove
the thread lifters from the slots.