Miele SBCD3 Classic C1 Allergy - Инструкция по эксплуатации - Страница 47

en

47

2. If you wish to replace exhaust filter 

b

or 

c

 with filter 

a

, you must insert the

new filter into a filter grille * before in-
stalling (dia. 27).

* Filter grille - see “Optional ac-
cessories”

When to change the thread lifters

The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.

How to replace the thread lifters
(dia. 29 + 30)



Use a suitable screwdriver to remove
the thread lifters from the slots.



Fit new thread lifters.

Cleaning the roller on the AllTeQ
floorhead (dia. 31)

Clean the roller on the floorhead if re-
quired.



Release the bearing (with bayonet fit-
ting) using a coin.



Press the bearing out, and remove.



Remove the roller.



Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.

Replacement parts are available from
your Miele dealer or from the Miele
Spare Parts Dept.

Cleaning and care



Always disconnect the vacuum

cleaner from the electrical supply be-
fore cleaning it. Switch off at the wall
socket and unplug it.

Vacuum cleaner and accessories

The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.



Do not use abrasive cleaning

agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!

Dust compartment

The dust compartment can, if neces-
sary, be cleaned using a 

dry

 duster,

brush or, if available, a second vacuum
cleaner to vacuum the dust out.



Do not let the vacuum cleaner

get wet! If moisture gets into the va-
cuum cleaner, there is a risk of elec-
tric shock.