Dreame T20 Pro - Инструкция по эксплуатации - Страница 7

5

EN

EN

Introduction of Display Screen

Electronic Lock/Reset Filter

•  Press briefly to enter/exit lock
•  Press and hold for 1.5 seconds to 

enter the filter reset interface

Suction Level Status

Lock Status

Switching Suction Level

•  Press briefly to switch the suction 

levels

Setting Language

Switching Suction Level

Note: If the vacuum is not working properly, the screen display will produce an error 

message. Please refer to the troubleshooting section to find your solution.

Note: The display screen will return to the main page if there is no operation for more than 

15 seconds.

Note: 

•  Stop the vacuum at any time while cleaning. It will continue to use the last selected 

suction level when starting again.

•  Connecting the smart multi-brush bar to the vacuum will activate the Auto Mode.
•  In this mode, the vacuum can automatically adjust its suction level depending on the 

surface type.

Press and hold the button        for 3 seconds to open the language list, then press the button                  
          to scroll through the language to select the desired one. Press and hold the button       
for 3 seconds to use the selected language.

Press the button          to switch between three suction levels of eco, med/auto, and turbo. 
The corresponding suction level will be highlighted on the display screen.
Auto Mode will be activated and "Auto" will appear on the display screen only when using 
the smart multi-brush bar. The vacuum will then automatically switch the suction level 
between the floor/tile and the carpet.

Product Overview