Philips SRU5060 - Инструкция по эксплуатации - Страница 5

Instructions for use

English

5

3

Check whether all the keys are working.
For an over view of the keys and their
functions see ‘3. Keys and functions’.

–

If the TV responds as it should to all of the
key commands the SRU 5060 is ready for use.

•

If the device does not respond at all or not to all of the 
key commands, follow the instructions under 
‘Setting the remote control’, or for online setup go to:
www.philips.com/urc.

Setting the remote control

This is only necessar y if your device does not respond to the SRU 5060.
If that is the case, the SRU 5060 does not recognize the brand and/or model
of your device and you need to program the remote control to do so.
The example below (TV) instructs you how to do this. You can repeat the
same steps for other devices (DVD, video recorder, etc.) which you want to
operate using the SRU 5060.

Automatically setting the remote control

The remote control will now automatically search for the right code for your
device.

Example of TV:

1

Make sure the TV is switched on and select a channel using the original
remote control or the keys on the TV (for example channel 1).

•

If the device is a DVD-player/recorder or video recorder, inser t a disk or
tape and star t playback.

2

Press the SELECT key to select TV.
Press the key until the Standby key lights up.

3

Then keep keys 1 and 3 

pressed 

simultaneously for three seconds

until the

Standby key flashes twice and then remains lit.

4

Press and hold the Standby key 
of the SRU 5060.

–

The SRU 5060 now star ts emitting all known 
‘TV off ’ signals, one by one.
Each time a code is sent, the Standby key 
lights up.

5

When your TV switches off (stand-by), release
the Standby key of the SRU 5060 immediately.

–

The SRU 5060 has now found a code that works on your TV.

6

Check if you can operate all functions on your TV with the SRU 5060.