Yamaha BD-S1067 - Инструкция по эксплуатации - Страница 45

Caution-i

 En

1

To assure the finest performance, please read this manual 
carefully. Keep it in a safe place for future reference.

2

Install this unit in a well ventilated, cool, dry, clean place – 
away from direct sunlight, heat sources, vibration, dust, 
moisture, and/or cold. For proper ventilation, allow the 
following minimum clearances.
Top: 10 cm (4 in)
Rear: 10 cm (4 in)
Sides: 10 cm (4 in) 

3

Locate this unit away from other electrical appliances, 
motors, or transformers to avoid humming sounds.

4

Do not expose this unit to sudden temperature changes from 
cold to hot, and do not locate this unit in an environment with 
high humidity (i.e. a room with a humidifier) to prevent 
condensation inside this unit, which may cause an electrical 
shock, fire, damage to this unit, and/or personal injury.

5

Avoid installing this unit where foreign object may fall onto 
this unit and/or this unit may be exposed to liquid dripping or 
splashing. On the top of this unit, do not place:

– Other components, as they may cause damage and/or 

discoloration on the surface of this unit.

– Burning objects (i.e. candles), as they may cause fire, 

damage to this unit, and/or personal injury.

– Containers with liquid in them, as they may fall and 

liquid may cause electrical shock to the user and/or 
damage to this unit.

6

Do not cover this unit with a newspaper, tablecloth, curtain, 
etc. in order not to obstruct heat radiation. If the temperature 
inside this unit rises, it may cause fire, damage to this unit, 
and/or personal injury.

7

Do not plug in this unit to a wall outlet until all connections 
are complete.

8

Do not operate this unit upside-down. It may overheat, 
possibly causing damage.

9

Do not use force on switches, knobs and/or cords.

10

When disconnecting the power cable from the wall outlet, 
grasp the plug; do not pull the cable.

11

Do not clean this unit with chemical solvents; this might 
damage the finish. Use a clean, dry cloth.

12

Only voltage specified on this unit must be used. Using this 
unit with a higher voltage than specified is dangerous and 
may cause fire, damage to this unit, and/or personal injury. 
Yamaha will not be held responsible for any damage resulting 
from use of this unit with a voltage other than specified.

13

To prevent damage by lightning, keep the power cable 
disconnected from a wall outlet or this unit during a lightning 
storm.

14

Do not attempt to modify or fix this unit. Contact qualified 
Yamaha service personnel when any service is needed. The 
cabinet should never be opened for any reasons.

15

When not planning to use this unit for long periods of time 
(i.e. vacation), disconnect the AC power plug from the wall 
outlet.

16

Be sure to read the “TROUBLESHOOTING” section on 
common operating errors before concluding that this unit is 
faulty.

17

Before moving this unit, press 

p

 to set this unit to the 

standby mode, and disconnect the AC power plug from the 
wall outlet.

18

Condensation will form when the surrounding temperature 
changes suddenly. Disconnect the power cable from the 
outlet, then leave this unit alone.

19

When using this unit for a long time, this unit may become 
warm. Turn the power off, then leave this unit alone for 
cooling.

20

Install this unit near the AC outlet and where the AC power 
plug can be reached easily.

21

The batteries shall not be exposed to excessive heat such as 
sunshine, fire or the like.

LASER SAFETY

This unit employs a laser. Due to possible eye injury, only a 
qualified service person should remove the cover or attempt 
to service this device.

DANGER

This unit emits visible laser radiation when open. Avoid 
direct eye exposure to beam. When this unit is plugged into 
the wall outlet, do not place your eyes close to the opening of 
the disc tray and other openings to look into inside.

CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.

This unit is not disconnected from the AC power source 
as long as it is connected to the wall outlet, even if this 
unit itself is turned off by 

p

. This state is called the 

standby mode. In this state, this unit is designed to 
consume a very small quantity of power.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC 
SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR 
MOISTURE.

The laser component in this product is capable of 
emitting radiation exceeding the limit for Class 1.

LASER Specification:

Class 1 LASER Product

Wave length: 790 nm (CDs)/655 nm (DVDs)/405 nm (BDs)
Laser output: max. 1 mW

CAUTION

Use of controls or adjustments or performance of 
procedures other than those specified herein may result 
in hazardous radiation exposure.