iv; Compliance and Conformity; Интерфейсные - Kyocera FS-1025MFP - Инструкция по эксплуатации - Страница 7

iv

Compliance and Conformity

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct 
the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• The use of a non-shielded interface cable with the referenced device is prohibited.

CAUTION 

—

 The changes or modifications not expressly approved by the party responsible for compliance could void the 

user’s authority to operate the equipment.

This device complies with Part 15 of FCC Rules.

Operation is subject to the following two conditions; (1) this device may not cause interference, and (2) this device must 
accept any interference, including interference that may cause undesired operation of the device.

* The above warning is valid only in the United States of America.

Интерфейсные

разъемы

ВАЖНО

Перед

подсоединением

или

отсоединением

интерфейсного

кабеля

убедитесь

, 

что

питание

аппарата

отключено

. 

Для

защиты

внутренних

электронных

частей

аппарата

от

статического

электричества

, 

которое

может

поступать

от

интерфейсных

разъемов

, 

закройте

каждый

разъем

защитным

колпачком

, 

входящим

в

комплект

поставки

.

CDRH Regulations

The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented 
regulations for laser products on August 2, 1976. These regulations apply to laser products manufactured after August 1, 
1976. Compliance is mandatory for products marketed in the United States. A label indicating compliance with the CDRH 
regulations must be attached to laser products marketed in the United States.

Canadian Department of Communications Compliance Statement

This Class B digital apparatus complies with Canadian ICES-003.

Avis de conformité aux normes du ministère des Communications du Canada 

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Примечание

Используйте

экранированные

интерфейсные

кабели

.