Smeg STC75 - Инструкция по эксплуатации - Страница 7

Installation instructions 

42

2.1 Water supply connection 

Preventing the risk of clogging or damage: 

if the water pipe is new or has 

not been used for a long time, before connecting to the water supply check 
that the water is clear and free of impurities, to prevent damage to the 
appliance. 

The dishwasher must always be connected to the water 

system with new hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY 

Connect the intake hose to a cold water supply with ¾” gas 
thread, inserting the filter 

A

 supplied with the dishwasher. 

Take care to screw the hose firmly into place with your 
hands and then complete by tightening about ¼ of a turn 
with pliers. 

In dishwashers equipped with the ACQUASTOP device, 
the filters is already fitted inside the threaded ring.

DRAIN CONNECTION 

Fit the drain hose into a pipe having diameter of 

at least 4 cm

; the 

dishwasher is 

fi

tted with a special device which allows column installation, 

even with the drain pipe below the level of the dishwasher. 

2.2 Electrical connection and precautions 

CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH 
THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON 
THE INNER EDGE OF THE DOOR. 

THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET 
OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN 
FORCE. 
THE PLUG MUST BE ACCESSIBLE AFTER INSTALLATION. 

NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY 
LEAD. 
IN THE EVENT OF DAMAGE TO THE SUPPLY CORD

, HAVE IT REPLACED 

BY THE MANUFACTURER OR AN AUTHORIZED TECHNICAL SERVICE 
CENTRE.

DO NOT USE ADAPTORS OR SHUNT CONNECTIONS

 IN ORDER TO AVOID 

THE POSSIBILITY OF OVERHEATING OR BURNING. 

GI