Smeg LSA4647X7 - Инструкция по эксплуатации - Страница 19

Installation instructions

2.1 Water supply connection

Preventing the risk of clogging or damage: 

if the water pipe is new or

has not been used for a long time, before connecting to the water supply
check that the water is clear and free of impurities, to prevent damage to
the appliance. 

The dishwasher must always be connected to the water

system with new hoses; old or used hoses must never be reused.

CONNECTING TO THE WATER SUPPLY

Connect the intake hose to a cold water supply with ¾”
gas thread, inserting the filter 

A

 supplied with the

dishwasher. 

Take care to screw the hose firmly into

place with your hands and then complete by
tightening about ¼ of a turn with pliers.

In dishwashers equipped with the ACQUASTOP
device, the filters is already fitted inside the threaded
ring.

The dishwasher can also be connected to a hot water supply 

not

exceeding 60°C

. Supplying the appliance with hot water cuts down the

washing time by approximately 20 minutes, but slightly reduces its
effectiveness. Make the connection to the domestic hot water supply using
the same procedure described for connecting to the cold water supply.

DRAIN CONNECTION

Insert the dishwasher’s drain hose
into a drain pipe having a diameter
of at least 

4 cm

, or alternatively,

place it inside the kitchen sink
using the plastic support provided,
taking care not to crush or
excessively bend the hose. It is
important to prevent the hose from
coming loose and falling. For this
purpose, the plastic support is
equipped with a hole for tying it to
the wall or water tap.

The free end should be positioned at a height of between 

30 and 100

cm

, and should never be submerged in water. If a horizontal drain

extension hose is used (for a maximum of 3 m) the drain hose can be
placed at a maximum height of 

85 cm

 from the ground.