Kaiser S 45 U 71 XL - Инструкция по эксплуатации - Страница 11

11

 EN 

1 

Connecting hot water 

The inlet hose of the appliance can be also 
connected to the hot water supply provided the 
temperature doesn’t exceed 60° C.  
 
 
In this case, both the wash cycle time and the 
power consumption are reduced. 
 
 
For hot water connection follow the same 
procedure as that for cold water. 

 
 
 
Connecting drain hose 



  Connect the drain hose to the drain pipe 

1

(diameter: 40 mm min.), or let it run directly 
into the sink 

2

. 

 
 
 
Use the special plastic hose support which is 
delivered with the appliance.  
 
 
The free end of the hose must be at a height of 
400 to 1000 mm and must not be immersed. Make 
sure that the hose is free from being bent or 
flattened. 
 
 

Disconnecting from water supply and 
sewerage 

To disconnect the Aqua-Stop inlet hose, cut off 
water supply by turning off the faucet, screw out 
the nut of the safety inlet hose which adjusts it to 
the faucet. 
 
Put the hose into the special storage compartment 
at the back of the dishwasher.  
 
 
In case the free end of the hose is put directly into 
the sink, pay attention to the following: 
 
If the sink is mounted at the height of 100 cm from 
the floor, the excess water cannot be drained 
directly into the sink.  
 
To drain the excess water from the hose in this 
case, you need a pail or any other suitable 
container which should be put below the sink at 
the side of it. 

1 

2