Smeg SX91SV9 - Инструкция по эксплуатации - Страница 6

Instructions

52

• Installation using a hose must be 

carried out so that the length of the 
hose does not exceed 2 metres 
when fully extended for steel hoses 
and 1.5 metres for rubber hoses.

• The hoses should not come into 

contact with moving parts and 
should not be crushed in any way.

• If required, use a pressure 

regulator that complies with 
current regulations.

• After carrying out any operation, 

check that the tightening torque of 
gas connections is between 
10 Nm and 15 Nm.

• At the end of the installation, check 

for any leaks with a soapy 
solution, never with a flame.

• Have the electrical connection 

performed by authorised 
technicians.

• The appliance must be connected 

to ground in compliance with 
electrical system safety standards.

• Use cables withstanding a 

temperature of at least 90 °C.

• The tightening torque of the screws 

of the terminal board leads must 
be 1.5 - 2 Nm.

For this appliance

• Ensure that the appliance is 

switched off before replacing the 
bulb.

• Do  not  rest  any  weight or sit on the 

open door of the appliance.

• Take care that no objects are stuck 

in the doors.

1.2 Manufacturer liability

The manufacturer declines all liability 
for damage to persons or property 
caused by:
• Use of the appliance other than 

that specified;

• failure to comply with the 

instructions in the user manual;

• tampering with any part of the 

appliance;

• use of non-original spare parts.