Kaiser HC 60040 Cs - Инструкция по эксплуатации - Страница 8

8 

 EN 

I

NSTALLATION 

Before using your new appliance, make sure to fit 
it properly. By fixing the adjustable feet in a proper 
position, you can keep the upper surface strictly 
horizontally and, thus, avoid backlash. For this 
purpose, take out the drawer at the bottom. 
The cooker is intended to be build up into kitchen 
furniture, however, only up to the height of the 
working plate, i.e. fixing up higher than 850 mm 
from the floor level is unreasonable. 
All materials used for furniture panels should be 
heat resistant at the temperature 100°C minimum. 
Breach of this regulation can result in distortion or 
ungluing of panel coverings. To avoid heat 
distortion of the furniture panels, ensure that the 
space between the contact surfaces is not less 
than 2 cm. 
 
 
Please mount the fume extractor hood at about 
600-700 mm above the cooking surface (see 
installation instructions for your fume extractor 
hood). 
 
 
 

PREPARATION 

Clean the oven thoroughly with soapy water and 
rinse well. Fit schelf support side rails and place in 
wire shelves and backing trays. 
Operate the oven for about 30 minutes at 
maximum temperature to burn off all traces of 
grease which might otherwise create unpleasant 
smells when cooking. 
 
 
 
 
 
 

Important !!! 

Safety precaution: before cleaning the oven, 
disconnect the plug from the electrical outlet or the 
power cable from the oven. Do not use acid or 
alkaline substances to clean the oven (lemon juice, 
vinegar, salt, tomatoes etc.). Do not use chlorine 
based products, acids or abrasive products to 
clean the painted surfaces of the oven. 
 
 
 

Attention! 

Set the time on the clock before 

you can use the oven.  
(See chapter 

„Electronic programmable 

control“

).  

If the time is not set, the oven cannot be 
operated.