Bomann DKP 5028 CB - Инструкция по эксплуатации - Страница 25

25

Unpacking the appliance

1.  Remove the appliance from its packaging.

2.  Remove all packaging materials such as films, filler mate

-

rial, cable clips and carton.

3.  To prevent hazards, check the appliance for any transport 

damage.

NOTE:

Production residue or dust may have collected on the appli

-

ance. We recommend cleaning the appliance according to 

chapter “Cleaning”.

Attaching the handles

The handles can be attached to the left and right side respec

-

tively.

The handles feature clamps that fit into the openings of the 

housing.
•  Push the clamps into the housing and secure by using the 

screws provided.

Electrical Connection

Connected load/wattage
The hob can take up an overall load of 2500 W. Because of 

this high connected load it is recommended to use a separate 

connection protected over a 16 A safety switch.

CAUTION: Overload!

Do not use extension cables or multiple sockets as the power 

consumption of this device is too high for these.

Connection
•  Before inserting the mains plug into the socket check 

whether the voltage which you intend to use corresponds 

to that of the machine. Please see the label on the machine 

for details.

•  Only connect the machine to a correctly installed safety 

socket.

Apply the following description to both hot plates:

Initial Operation of the Unit

Before first use, operate the unit for 5 minutes to remove the 

protective coating of the hotplate. Set the thermostatic control

-

ler to MAX.

NOTE:

Occurrence of light smoke and odours is normal with this 

procedure. Take care of suitable ventilation.

Using the Hotplate

Switching on/off
The unit is switched on with the thermostatic controller. 

The unit is switched off when the thermostatic controller is set 

to MIN.

Notes for cooking utensils
•  For optimum use of energy, use only pots/pans with a flat 

bottom (see Fig.).

•  The cooking utensil never should be smaller than the hot-

plate. This wastes energy. In extreme cases, the hotplate 

can become distorted.

Operation
Use the thermostatic controller to select the temperature of the 

hotplate according to the purpose:
Notch 1: 

Warming up

Notch 2: 

Warming up/simmering 

Notch 3: 

Simmering

Notch 4: 

Frying 

Notch 5: 

Parboiling, browning

Notch MAX:  

Browning, quick heating

NOTE:

The pilot lamp indicates the heating up of the hotplate. It is 

switched on and off during operation. This is normal and 

indicates that the temperature is controlled and maintained 

by the thermostatic controller.

Switching Off
•  Set the thermostatic controller to MIN.

•  Remove the mains plug from the socket.

•  Let the unit cool down before storing it.

WARNING: Hazard of burns! 

Because of the heat radiated during cooking, dangerously 

high temperatures may occur at the cooking zone after the 

cooking cycle.