Makita LH1040F - Инструкция по эксплуатации - Страница 20

20

(2) 45° bevel angle 

Adjust the 45° bevel angle only after performing 0°
bevel angle adjustment. To adjust left 45° bevel
angle, loosen the lever and tilt the blade to the left
fully. Make sure that the pointer on the arm points to
45° on the bevel scale on the arm. If the pointer
does not point to 45°, turn the 45° bevel angle
adjusting bolt on the left side of the arm until the
pointer points to 45°. 

(Fig. 56) 

Replacing carbon brushes (Fig. 57 & 58)

Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, inser t the new ones and
secure the brush holder caps.

After use

• After use, wipe off chips and dust adhering to the tool

with a cloth or the like. Keep the blade guard clean
according to the directions in the previously covered
section titled “Blade guard”. Lubricate the sliding por-
tions with tool oil to prevent rust.

To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.

ACCESSORIES 

CAUTION:
• These accessories or attachments are recommended

for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.

If you need any assistance for more details regarding
these accessories, ask your local Makita service center.

• Steel & Carbide-tipped saw blades 
• Auxiliary plate 
• Vise assembly (Horizontal vise) 
• Ver tical vise 
• Socket wrench 13
• Holder set 
• Holder assembly 
• Holder rod assembly 
• Set plate 
• Dust bag 
• Triangular rule 
• Blade cover (Blade guard C) 
• Push stick 
• Ruler assembly (Rip fence)

Noise and Vibration

ENG005-1

The typical A-weighted noise levels are 

sound pressure level: 92 dB (A)
sound power level:

105 dB (A)

– Wear ear protection. –

The typical weighted root mean square acceleration
value is not more than 2.5 m/s

2

.

EC-DECLARATION OF CONFORMITY 

ENH003-1

We declare under our sole responsibility that this product is
in compliance with the following standards of standardized
documents, 

EN61029, EN55014, EN61000

in accordance with Council Directives, 73/23/EEC, 
89/336/EEC and 98/37/EC.
Certificate of adequacy of the technical file with respect
to 98/37/EC having been obtained from the following
notified body:
Inter tek SEMKO AB, Torshamnsgatan 43, Box 1103, 
SE-164 22 Kista, Sweden

Yasuhiko Kanzaki

CE2004

Director

MAKITA INTERNATIONAL EUROPE LTD.

Michigan Drive, Tongwell, Milton Keynes, 
Bucks MK15 8JD, ENGLAND